Same Diamond

Automatic transmission fluid capacity & service interval

Same Diamond automatic transmission fluid capacity ranges from 79 to 81 liters. Service intervals include checks at 50 and 250 hours, with changes required at 1000 hours or 12 months. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Diamond 230 DCR, -> WSXJ360200LS10001 (2008-2014)
  • Use: Normal
  • Capacity 79 liter (Rigid rear axle)
  • Capacity 81 liter (Suspended rear axle)
  • Check 50 hours
  • Change 1000 hours/ 12 months
Diamond 230 DCR, -> WSXL880200LS10001 (2008-2014)
  • Use: Normal
  • Capacity 79 liter (Rigid rear axle)
  • Capacity 81 liter (Suspended rear axle)
  • Check 250 hours
  • Change 1000 hours/ 12 months
Diamond 270 DCR, -> WSXJ370200LS10001 (2008-2014)
  • Use: Normal
  • Capacity 79 liter (Rigid rear axle)
  • Capacity 81 liter (Suspended rear axle)
  • Check 50 hours
  • Change 1000 hours/ 12 months
Diamond 270 DCR, -> WSXL910200LS10001 (2008-2014)
  • Use: Normal
  • Capacity 79 liter (Rigid rear axle)
  • Capacity 81 liter (Suspended rear axle)
  • Check 50 hours
  • Change 1000 hours/ 12 months

Additional Notes

  • The Same Diamond 230 DCR and 270 DCR transaxle/transmission capacities differ based on rear axle configuration, with the rigid rear axle requiring 79 liters and the suspended rear axle requiring 81 liters across all four serial number ranges covered in the 2008-2014 specifications.
  • A 2-liter difference between the rigid and suspended rear axle configurations reflects the additional fluid volume needed to service the suspension-integrated axle assembly compared to a fixed axle setup.
  • The Diamond 230 DCR units up to serial number WSXJ360200LS10001 carry a fluid check interval of 50 hours under normal use conditions, while units up to WSXL880200LS10001 specify a notably longer check interval of 250 hours under the same normal use conditions.
  • Despite the difference in check intervals between the two Diamond 230 DCR serial ranges, both share an identical fluid change interval of 1000 hours or 12 months, whichever comes first, under normal use conditions.
  • All four configurations across the Diamond 230 DCR and 270 DCR share the same fluid change interval of 1000 hours or 12 months under normal use conditions, indicating a consistent drain cycle regardless of serial number range or model designation.
  • The three Diamond 270 DCR serial ranges covered by serials up to WSXJ370200LS10001 and WSXL910200LS10001 both specify a 50-hour fluid check interval, aligning with the shorter check schedule seen in the Diamond 230 DCR WSXJ360200LS10001 range rather than the 250-hour interval of the WSXL880200LS10001 range.
  • The 79-liter and 81-liter capacity figures represent substantial fluid volumes consistent with large-scale agricultural or industrial equipment transaxle/transmission systems, where high fluid volumes support thermal management and lubrication across extended operating cycles.

Other Systems