Same Antares, Galaxy, Titan I/II

Brake fluid capacity & service interval

Same Antares, Galaxy, and Titan I/II models require 0,8 liter of brake fluid. Service intervals include 300 hours or 24 months. The data covers 7 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Titan 150 II (2000-2005)
  • Use: Normal
  • Capacity 0,8 liter
  • Check 300 hours
  • Change 24 months
Titan 160 II (2000-2005)
  • Use: Normal
  • Capacity 0,8 liter
  • Check 300 hours
  • Change 24 months
Titan 190 II (2000-2005)
  • Use: Normal
  • Capacity 0,8 liter
  • Check 300 hours
  • Change 24 months
Titan 145 (1994-2005)
  • Use: Normal
  • Capacity 0,8 liter
  • Check 300 hours
  • Change 24 months
Titan 150 (1994-2005)
  • Use: Normal
  • Capacity 0,8 liter
  • Check 300 hours
  • Change 24 months
Titan 160 (1992-2005)
  • Use: Normal
  • Capacity 0,8 liter
  • Check 300 hours
  • Change 24 months
Titan 190 (1992-2005)
  • Use: Normal
  • Capacity 0,8 liter
  • Check 300 hours
  • Change 24 months

Additional Notes

  • All Same Titan I and Titan II variants covered in these specifications share a hydraulic brake/clutch system capacity of 0.8 liter, indicating a combined circuit where brake and clutch actuation draw from a single fluid reservoir rather than separate dedicated systems.
  • The 0.8 liter capacity figure represents the service fill volume for the hydraulic circuit, which is the amount of fluid the system holds under normal operating conditions rather than a total overhaul or bench-fill measurement.
  • A check interval of 300 hours is an operating-hours-based schedule, common in agricultural and heavy equipment applications where annual mileage is not a reliable measure of mechanical wear or fluid degradation.
  • The change interval of 24 months applies uniformly across all listed Titan variants regardless of operating hours accumulated, meaning calendar time alone can trigger a fluid replacement even if the 300-hour check threshold has not been reached.
  • Brake fluid absorbs moisture over time through a process called hygroscopic absorption, which lowers the fluid's boiling point. A 24-month change interval addresses this degradation mechanism independently of how frequently the machine is operated.
  • The Titan 160 and Titan 190 model lines each span from 1992-2005, while the corresponding Series II variants of both models share a narrower production window of 2000-2005, yet all carry identical hydraulic brake/clutch fluid specifications.
  • The Titan 150 and Titan 145 variants, introduced in 1994, carry the same 0.8 liter capacity and service intervals as the Titan 160 and Titan 190 models that entered production two years earlier in 1992, indicating a standardized hydraulic system design across the Titan range.
  • All specifications listed are classified under normal use conditions, meaning the 300-hour check and 24-month change intervals are not adjusted for more demanding operating environments such as dusty, wet, or high-load agricultural conditions.

Other Systems