Same Argon

Brake fluid capacity & service interval

Same Argon uses brake fluid with a capacity of 1 liter. Service intervals occur every 50 hours. The data covers 8 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Argon 100, Stage 3B->ZKDRK30200RS50001 (2018- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
Argon 100, Stage 3B->ZKDEE50200RS10001 (2018- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
Argon 70, Stage 3B->ZKDEE20200RS10001 (2018- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
Argon 70, Stage 3B->ZKDRK00200RS50001 (2018- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
Argon 80, Stage 3B->ZKDRK10200RS50001 (2018- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
Argon 80, Stage 3B->ZKDEE30200RS10001 (2018- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
Argon 90, Stage 3B->ZKDRK20200RS50001 (2018- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
Argon 90, Stage 3B->ZKDEE40200RS10001 (2018- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours

Additional Notes

  • The Same Argon hydraulic brake system holds 1 liter of brake fluid across all listed variants, including the Argon 70, 80, 90, and 100. A 1-liter capacity is typical for a tractor hydraulic brake circuit, reflecting the volume needed to fill the master cylinder reservoir, lines, and caliper or wheel cylinder assemblies.
  • Each variant listed carries a Stage 3B engine designation, which refers to a European non-road mobile machinery (NRMM) emissions certification tier. All eight configurations share identical brake fluid capacity and check interval values regardless of power output differences between the 70, 80, 90, and 100 model designations.
  • The 50-hour check interval applies under normal use conditions across every listed configuration. In agricultural equipment, a 50-hour interval is a relatively frequent service point, often aligned with seasonal or routine field maintenance schedules rather than calendar-based intervals.
  • Each row specifies a check interval rather than a change interval. A brake fluid check at 50 hours involves inspecting fluid level and condition without necessarily replacing the fluid, distinguishing routine monitoring from a full service drain-and-fill procedure.
  • The specifications are organized by serial number break points, with each variant identified by a VIN-style serial prefix beginning at a specific unit number. The two serial series per model variant, one beginning with ZKDEE and one with ZKDRK, likely correspond to different production lines or regional build sequences, yet both carry the same 1-liter capacity and 50-hour check interval.

Other Systems