Massey Ferguson 4200

Coolant capacity & service interval

Massey Ferguson 4200 coolant capacity ranges from 10 to 28 liters. Service intervals include checking at 10 hours and changing at 1000 hours. The data covers 8 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
MF 4215 (1997-2001)
  • Use: Normal
  • Capacity 10 liter
  • Check 10 hours
  • Change 1000 hours
MF 4220 (1997-2001)
  • Use: Normal
  • Capacity 10 liter
  • Check 10 hours
  • Change 1000 hours
MF 4225 (1997-2001)
  • Use: Normal
  • Capacity 15 liter
  • Check 10 hours
  • Change 1000 hours
MF 4235 (1997-2001)
  • Use: Normal
  • Capacity 15 liter
  • Check 10 hours
  • Change 1000 hours
MF 4245 (1997-2001)
  • Use: Normal
  • Capacity 15 liter
  • Check 10 hours
  • Change 1000 hours
MF 4255 (1997-2001)
  • Use: Normal
  • Capacity 15 liter
  • Check 10 hours
  • Change 1000 hours
MF 4260 (1997-2001)
  • Use: Normal
  • Capacity 28 liter
  • Check 10 hours
  • Change 1000 hours
MF 4270 (1997-2001)
  • Use: Normal
  • Capacity 28 liter
  • Check 10 hours
  • Change 1000 hours

Additional Notes

  • Cooling system capacities across the Massey Ferguson 4200 series fall into three distinct groups: 10 liters for the MF 4215 and MF 4220, 15 liters for the MF 4225 through MF 4255, and 28 liters for the MF 4260 and MF 4270. These differences reflect the larger engine displacements and greater thermal loads associated with the higher-numbered models.
  • The 28-liter cooling system capacity on the MF 4260 and MF 4270 is notably high relative to the rest of the range. In agricultural tractors, a larger coolant volume generally corresponds to a bigger block and more cylinders, requiring a greater fluid mass to absorb and dissipate heat during sustained field operation.
  • The 10-liter capacity shared by the MF 4215 and MF 4220 represents the smallest cooling system in the 4200 series. At this volume, the system is sized for the lower-output engines at the entry end of the lineup.
  • All eight models in the 4200 series carry a coolant check interval of 10 hours under normal use conditions. In tractor servicing, a 10-hour check interval is a short-cycle inspection task, typically aligned with daily or near-daily operation checks rather than scheduled drain-and-fill service.
  • The coolant change interval is 1000 hours across all models in the range, applied uniformly under normal use conditions. In agricultural equipment, 1000 hours is a standard long-cycle service point, often reached over one or more full seasons of field use depending on annual operating hours.
  • The MF 4225, MF 4235, MF 4245, and MF 4255 all share the same 15-liter cooling system capacity despite representing a spread of model designations within the series. A shared capacity across multiple models in a lineup typically indicates a common engine block or cooling circuit architecture across those variants.
  • All specifications listed apply to normal use conditions. In equipment service terminology, normal use refers to operation within standard load, temperature, and duty-cycle parameters, as opposed to severe conditions that might involve extreme ambient temperatures, heavy continuous loads, or dusty environments.

Other Systems