Massey Ferguson 1000
Power steering fluid capacity & service interval
Massey Ferguson 1000 uses power steering fluid with a capacity range of 1 to 4 liters. The data covers 6 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| MF 1004 (1985-1991) |
|
| MF 1004T (1985-1991) |
|
| MF 1014 (1985-1991) |
|
| MF 1080/A (1985-1991) |
|
| MF 1114 (1985-1991) |
|
| MF 1134 (1985-1991) |
|
Additional Notes
- All six Massey Ferguson 1000 series variants covered in these specifications share a hydraulic steering system architecture, meaning the power steering fluid capacity figures reflect the volume held within a hydraulic circuit rather than an electric or electro-hydraulic assist unit.
- The Massey Ferguson MF 1004 carries a 1 liter capacity, the smallest figure across the entire 1000 series group listed here, which is consistent with a compact hydraulic steering circuit requiring a relatively modest fluid volume.
- The MF 1004T is rated at 2.8 liters, nearly three times the capacity of the non-turbocharged MF 1004, indicating a meaningfully larger hydraulic steering circuit despite sharing the same model year range of 1985-1991.
- The MF 1014, MF 1114, and MF 1134 each share an identical capacity range of 2-4 liters. A range specification of this kind typically reflects variation between a partial service fill and a full system drain-and-refill, or accounts for differences in optional equipment configurations that affect reservoir and line volume.
- The MF 1080/A presents two distinct capacity values within a single model entry: 1.1 liters for the standard configuration and 2.8 liters for the 4x4 variant. The higher figure for the four-wheel-drive version reflects the additional hydraulic components associated with front axle steering assist in a 4x4 drivetrain layout.
- All specifications across the 1985-1991 model year range are designated for normal use conditions, meaning none of the listed capacities or service parameters carry a separate severe-duty or first-change-only qualification.