Lindner N, A
Manual transmission fluid capacity & service interval
Lindner N, A models require manual transmission fluid with a capacity range of 22 to 28 liters. Service intervals consist of a check every 500 hours and a change every 1000 hours. The data covers 10 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| 1600 N, A (1994- ) |
|
| 1650 N, A (1994- ) |
|
| 1700 N, A (1994- ) |
|
| 1750 N, A (1994- ) |
|
| 1450 N, A (1990- ) |
|
| 1500 N, A (1990- ) |
|
| 1600 N, A (1990-1994) |
|
| 1650 N, A (1990-1994) |
|
| 1700 N, A (1990-1994) |
|
| 1750 N, A (1990-1994) |
|
Additional Notes
- All specifications listed apply to normal use conditions, meaning the check and change intervals are not adjusted for severe or demanding operating environments.
- Service intervals across all listed models are measured in engine hours rather than distance or calendar time, which is standard practice for agricultural and industrial machinery where annual mileage is not a meaningful metric.
- The Lindner 1450 N, A and 1500 N, A models from 1990 onward share an identical transaxle manual fluid capacity of 22 liters, placing them in the lowest capacity group among the listed configurations.
- Models in the 1600, 1650, 1700, and 1750 N, A range built between 1990-1994 carry a transaxle capacity of 24.5 liters, which is notably larger than the 22-liter figure seen in the 1450 and 1500 models.
- Starting in 1994, the 1600, 1650, 1700, and 1750 N, A models saw a transaxle capacity increase to 28 liters, representing a rise of 3.5 liters over the pre-1994 specification for those same model lines.
- A 28-liter transaxle fill volume is substantial for a manual unit and reflects the integrated transaxle design common in larger agricultural tractors, where the transmission, rear axle, and differential share a single fluid reservoir.
- The fluid level check interval of 500 hours applies uniformly across all listed models, meaning a check is due at the halfway point of each full change cycle.
- The change interval of 1000 hours is consistent across every listed configuration regardless of model or capacity, indicating a standardized drain-and-refill schedule for the entire N, A range covered here.