Hürlimann XV V-DRIVE
Brake fluid capacity & service interval
Hürlimann XV V-DRIVE uses brake fluid with a capacity of 1 liter. Service intervals require a check every 50 hours. The data covers 5 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| XV 100 V-DRIVE, ->ZKDEN10200TH50001 (2019- ) |
|
| XV 105 V-DRIVE, ->ZKDEN90200TH50001 (2019- ) |
|
| XV 115 V-DRIVE, ->ZKDEP30200TH50001 (2019- ) |
|
| XV 90 V-DRIVE, ->ZKDEM70200TH50001 (2019- ) |
|
| XV 90.4 V-DRIVE, ->ZKDEN50200TH50001 (2019- ) |
|
Additional Notes
- Across all five variants of the Hürlimann XV V-DRIVE covered by the 2019 specifications — the XV 90, XV 90.4, XV 100, XV 105, and XV 115 — the hydraulic brake system carries a uniform capacity of 1 liter.
- A 1-liter capacity for a hydraulic brake system is a relatively modest volume, consistent with the reservoir and line fill typical of compact-to-mid-range tractor braking circuits rather than large-scale hydraulic actuation systems.
- The check interval for the hydraulic brake system is set at every 50 hours of operation under normal use conditions across all listed variants.
- A 50-hour brake fluid check interval is notably frequent by general agricultural equipment standards, reflecting the safety-critical nature of braking systems and the demanding operating environments tractors commonly encounter.
- The specifications apply to serial numbers beginning at or above the thresholds listed for each variant — ZKDEM70200TH50001 for the XV 90, ZKDEN50200TH50001 for the XV 90.4, ZKDEN10200TH50001 for the XV 100, ZKDEN90200TH50001 for the XV 105, and ZKDEP30200TH50001 for the XV 115 — meaning the capacity and interval figures are tied to specific production runs rather than the entire model line without qualification.
- The consistency of both the 1-liter capacity and the 50-hour check interval across the XV 90 through XV 115 power variants indicates that differences in engine output among the variants do not correspond to any variation in brake fluid system specifications.