Hürlimann XS V-DRIVE
Differential fluid capacity & service interval
Hürlimann XS V-DRIVE uses differential fluid with a capacity of 6 liters. Service intervals include checking every 300 hours and changing every 1200 hours or 12 months. The data covers 10 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Additional Notes
- The front differential fluid capacity across all Hürlimann XS V-DRIVE configurations listed is 6 liters. In agricultural machinery, a front differential fill of this volume is consistent with a service-fill specification rather than a full overhaul or disassembly fill, which would typically require additional fluid to account for internal passages and components drained during teardown.
- The 6-liter front differential capacity is uniform across all power variants in the XS V-DRIVE range, covering the XS 90, XS 90.4, XS 95, XS 100, XS 105, and XS 115 models. No variation in capacity exists between the lower and higher horsepower configurations within the specifications.
- Stage 3B and Stage 5 engine designations refer to different European emissions compliance tiers. Stage 3B applies to engines meeting an earlier EU off-road emissions standard, while Stage 5 reflects a more stringent standard introduced later. Both emission stages appear across the XS V-DRIVE lineup, with Stage 3B configurations starting from 2020 and Stage 5 configurations starting from 2022.
- The front differential fluid check interval is set at 300 hours under normal use conditions. In tractor operation, a 300-hour check interval is a relatively frequent inspection point, intended to verify fluid level and condition without necessarily performing a full fluid change.
- The fluid change interval is specified at 1200 hours or 12 months, whichever comes first, under normal use conditions. The dual-trigger format means that calendar time can mandate a change even when the hourly threshold has not been reached, which is relevant for machines operating at lower annual hours.
- The ratio between the check interval and the change interval is 1:4, meaning four check intervals occur for every one full fluid change cycle. This structure allows for fluid level and contamination monitoring at regular intervals before the full replacement is due.
- Each configuration in the specifications is identified by a unique serial number prefix following the arrow notation, such as ZKDEK70200TH50001 for the XS 100 V-DRIVE Stage 3B. These serial number thresholds indicate the production point from which the listed specifications apply, rather than a model year alone.
- The XS 90.4 V-DRIVE appears only in a Stage 3B configuration within the specifications, starting from 2020, while the XS 95 V-DRIVE appears only in a Stage 5 configuration starting from 2022. The remaining models, XS 90, XS 100, XS 105, and XS 115, each have both a Stage 3B and a Stage 5 variant listed.