Hürlimann XA V-DRIVE

Differential fluid capacity & service interval

Hürlimann XA V-DRIVE differential fluid capacity is 6 liters. Service intervals include checks every 300 hours and changes every 1200 hours or 12 months. The data covers 8 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • XA 105 V-DRIVE, Stage 5->ZKDHU30200TH50001 (2022- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • XA 115 V-DRIVE, Stage 5->ZKDHU40200TH50001 (2022- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • XA 95 V-DRIVE, Stage 5->ZKDHU20200TH50001 (2022- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • XA 100 V-DRIVE, Stage 3B->ZKDEU70200TH50001 (2019- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • XA 100.4 V-DRIVE, Stage 3B->ZKDEU70200TH50001 (2019- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • XA 110.4 V-DRIVE, Stage 3B->ZKDEV10200TH50001 (2019- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • XA 90 V-DRIVE, Stage 3B->ZKDET50200TH50001 (2019- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • XA 90.4 V-DRIVE, Stage 3B->ZKDEU30200TH50001 (2019- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months

Additional Notes

  • All eight configurations of the Hürlimann XA V-DRIVE share an identical front differential fluid capacity of 6 liters, indicating a uniform housing design across the entire model range regardless of power output or emission stage.
  • A 6-liter capacity for a front differential is relatively substantial, reflecting the demands of a four-wheel-drive agricultural tractor where the front axle differential must handle significant torque loads under field conditions.
  • The check interval of 300 hours applies under normal use conditions across all listed configurations, meaning fluid level and condition are inspected roughly three times before a full drain-and-fill service becomes due.
  • The change interval is set at 1200 hours or 12 months under normal use conditions, whichever comes first. The dual-trigger structure accounts for tractors with lower annual operating hours, where calendar aging of the fluid becomes the limiting factor before the hour threshold is reached.
  • Stage 3B configurations covering the XA 90, XA 90.4, XA 100, XA 100.4, and XA 110.4 V-DRIVE all carry starting serial numbers from 2019, while the Stage 5 configurations covering the XA 95, XA 105, and XA 115 V-DRIVE carry starting serial numbers from 2022. Despite the difference in emission stage and introduction year, the front differential fluid capacity and service intervals are identical across both groups.
  • Stage 3B and Stage 5 refer to European non-road mobile machinery emission standards, with Stage 5 representing a stricter tier introduced later. The front differential specifications remaining unchanged between the two stages suggests the drivetrain hardware was carried over independently of engine emission upgrades.
  • The ratio of one check per 300 hours to one change per 1200 hours means three intermediate inspections occur between each fluid replacement, allowing early detection of contamination or level loss without committing to a full service at each interval.

Other Systems