Goldoni Aster series

Differential fluid capacity & service interval

Goldoni Aster series differential fluid capacity ranges from 2,85 to 3,15 liters. Service intervals include a check at 50 hours and a change at 800 hours. The data covers 3 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Aster 35 (TX1A/TX1B/TX2A/TX2B), Lombardini LDW1503
  • Front
  • Use: Normal
  • Capacity 2,85 liter
  • Check 50 hours
  • Change 800 hours
  • Aster 40 (TX3A/TX3B/TX4A/TX4B), Lombardini LDW1603
  • Front
  • Use: Normal
  • Capacity 2,85 liter
  • Check 50 hours
  • Change 800 hours
  • Aster 45 (TX5A/TX6A), Lombardini LDW2204
  • Front
  • Use: Normal
  • Capacity 3,15 liter
  • Check 50 hours
  • Change 800 hours

Additional Notes

  • The Goldoni Aster 35 paired with the Lombardini LDW1503 engine carries a front differential fluid capacity of 2.85 liters, a figure that reflects a service fill volume rather than a full overhaul drain-and-refill quantity in most field maintenance contexts.
  • The Aster 40 with Lombardini LDW1603 engine shares the same 2.85-liter front differential capacity as the Aster 35, indicating a common front axle assembly across both configurations despite the difference in engine displacement.
  • Moving to the Aster 45 with Lombardini LDW2204 engine, the front differential capacity increases to 3.15 liters, a step up of 0.30 liters relative to the smaller-engine variants, consistent with the heavier-duty front axle typically associated with higher-horsepower tractor configurations.
  • Across all three Aster series configurations, the fluid check interval is set at 50 operating hours under normal use conditions, a relatively short interval that reflects the importance of early detection of fluid loss or contamination in front differential assemblies.
  • The change interval for front differential fluid is 800 operating hours across all listed Aster variants under normal use conditions, a figure expressed in hours rather than calendar time, which is standard practice for agricultural equipment where annual usage varies widely between operators.
  • The TX1A, TX1B, TX2A, and TX2B transmission codes associated with the Aster 35 suggest multiple gearbox variants within a single engine-model pairing, yet all share the same 2.85-liter front differential capacity and identical service intervals.
  • The Aster 40 similarly spans four transmission variants (TX3A, TX3B, TX4A, TX4B), and the front differential specifications remain uniform at 2.85 liters with 50-hour checks and 800-hour changes regardless of which transmission variant is installed.

Other Systems