Fendt Farmer 300 C

Manual transmission fluid capacity & service interval

Fendt Farmer 300 C manual transmission fluid capacity ranges from 34,5 to 37,5 liters. Service intervals include checks at 10 and 250 hours, and changes at 2000 hours or 24 months. The data covers 11 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Farmer 307 Ci, 117/../8001 -> (2004-2008)
  • Use: Normal
  • Capacity 35,5 liter
  • Capacity 37,5 liter (+ front wheel drive)
  • Check 10 hours
  • Change 2000 hours/ 24 months
Farmer 308 Ci, 118/../8001 -> (2004-2008)
  • Use: Normal
  • Capacity 35,5 liter
  • Capacity 37,5 liter (+ front wheel drive)
  • Check 10 hours
  • Change 2000 hours/ 24 months
Farmer 309 Ci, 119/../8001 -> (2004-2008)
  • Use: Normal
  • Capacity 35,5 liter
  • Capacity 37,5 liter (+ front wheel drive)
  • Check 10 hours
  • Change 2000 hours/ 24 months
Farmer 307 C, 117/../0001 -> 117/../5000 (1998-2001)
  • Use: Normal
  • Capacity 34,5 liter
  • Check 250 hours
  • Change 2000 hours/ 24 months
  • Code: (4x2) 21/6
Farmer 307 C, 117/../0001 -> 117/../5000 (1998-2001)
  • Use: Normal
  • Capacity 36,5 liter
  • Check 250 hours
  • Change 2000 hours/ 24 months
  • Code: (4x4) 21/6
Farmer 307 C, 117/../5001 -> (1998-2001)
  • Use: Normal
  • Capacity 37,5 liter
  • Check 10 hours
  • Change 2000 hours/ 24 months
  • Code: 21/21
Farmer 308 C, 118/../0001 -> 118/../5000 (1998-2001)
  • Use: Normal
  • Capacity 34,5 liter
  • Check 250 hours
  • Change 2000 hours/ 24 months
  • Code: (4x2) 21/6
Farmer 308 C, 118/../0001 -> 118/../5000 (1998-2001)
  • Use: Normal
  • Capacity 36,5 liter
  • Check 250 hours
  • Change 2000 hours/ 24 months
  • Code: (4x4) 21/6
Farmer 308 C, 118/../5001 -> (1998-2001)
  • Use: Normal
  • Capacity 37,5 liter
  • Check 10 hours
  • Change 2000 hours/ 24 months
  • Code: 21/21
Farmer 309 C, 119/../0001 -> 119/../5000 (1998-2001)
  • Use: Normal
  • Capacity 36,5 liter
  • Check 250 hours
  • Change 2000 hours/ 24 months
  • Code: (4x4) 21/6
Farmer 309 C, 119/../5001 -> (1998-2001)
  • Use: Normal
  • Capacity 37,5 liter
  • Check 10 hours
  • Change 2000 hours/ 24 months
  • Code: 21/21

Additional Notes

  • The Fendt Farmer 300 C transaxle manual transmission fluid capacities range from 34.5 liters to 37.5 liters depending on the model variant and serial number range. These large fluid volumes are characteristic of agricultural tractor transaxles, which integrate the transmission, rear axle, and hydraulic systems into a single shared oil circuit.
  • Within the Farmer 307 C, 308 C serial range 0001 through 5000 (1998-2001), two separate capacity values are listed: 34.5 liters and 36.5 liters. This dual listing reflects different fill levels applicable to the same serial range, likely corresponding to different equipment configurations or fill points within that production batch.
  • From serial number 5001 onward on the 307 C and 308 C (1998-2001), the capacity consolidates to a single value of 37.5 liters, which is the highest capacity figure across all non-front-wheel-drive variants in the 307 C and 308 C lines.
  • The 309 C serial range 0001 through 5000 (1998-2001) lists only a single capacity of 36.5 liters, unlike the 307 C and 308 C equivalents in the same serial range, which carry a lower 34.5-liter figure alongside the 36.5-liter value.
  • The Ci variants of the 307, 308, and 309 (2004-2008) each specify two distinct capacities: 35.5 liters as the base figure and 37.5 liters when the tractor is equipped with front wheel drive. The additional 2 liters accounts for the fluid volume required by the front axle drive components integrated into the transaxle circuit.
  • The fluid check interval differs significantly between serial number groups. Units in the 0001 through 5000 range carry a 250-hour check interval, while units from serial 5001 onward and all Ci variants specify a 10-hour check interval. A 10-hour interval corresponds to a break-in or early-operation check, typically performed after initial use to detect contamination or abnormal wear before the standard service schedule begins.
  • The fluid change interval is consistent across all Farmer 300 C variants and serial ranges at 2000 hours or 24 months, whichever comes first. The time-based limit of 24 months ensures fluid degradation from oxidation and moisture absorption is addressed even in low-utilization applications where the hour threshold may not be reached within a reasonable period.

Other Systems