Deutz-Fahr Series 6 W Profi

Differential fluid capacity & service interval

Deutz-Fahr Series 6 W Profi differential fluid capacity ranges from 5,5 to 5,8 liters. Service intervals include checking at 250 hours and changing at 1000 hours or 12 months. The data covers 7 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • 6130 W Profi, ->DF1DU902W0CD10001 (2020- )
  • Front
  • Use: Normal
  • Capacity 5,5 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 6135 W Profi PS, ->DF1GK202W0CD10001 (2020- )
  • Front
  • Use: Normal
  • Capacity 5,8 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 6145 W Profi, ->DF1DT802W0CD1000 (2020- )
  • Front
  • Use: Normal
  • Capacity 5,5 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 6155 W Profi PS, ->DF1GK302W0CD10001 (2020- )
  • Front
  • Use: Normal
  • Capacity 5,8 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 6165 W Profi, ->DF1DT902W0CD10001 (2020- )
  • Front
  • Use: Normal
  • Capacity 5,5 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 6175 W Profi PS, ->DF1GK402W0CD10001 (2020- )
  • Front
  • Use: Normal
  • Capacity 5,8 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 6180 W Profi, ->DF1DU002W0CD10001 (2020- )
  • Front
  • Use: Normal
  • Capacity 5,5 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months

Additional Notes

  • Across the Deutz-Fahr Series 6 W Profi lineup from 2020, front differential fluid capacities fall into two distinct values: 5.5 liters and 5.8 liters, depending on the specific variant.
  • The 5.5-liter front differential capacity applies to the 6130 W Profi, 6145 W Profi, 6165 W Profi, and 6180 W Profi variants, all sharing identical service fill volumes despite differing power outputs.
  • The 5.8-liter front differential capacity is specific to the PS-designated variants: the 6135 W Profi PS, 6155 W Profi PS, and 6175 W Profi PS. The slightly higher volume relative to non-PS counterparts corresponds to the PS (Power Shift) transmission configuration, which may involve a differently dimensioned front axle differential housing.
  • A 5.5-liter or 5.8-liter service fill capacity is consistent with a front axle differential on a mid-to-large agricultural tractor, reflecting the volume needed to maintain adequate lubrication across the gear set and bearings under field operating conditions.
  • All seven variants share an identical fluid check interval of 250 hours under normal use conditions, indicating a standardized inspection schedule across the Series 6 W Profi range regardless of PS or non-PS designation.
  • The fluid change interval for all listed variants is 1,000 hours or 12 months under normal use conditions, whichever comes first. The dual-trigger structure means calendar time can mandate a change even when the hourly threshold has not been reached, which is relevant for lower-utilization machines.
  • All specifications are classified under normal use conditions. In agricultural equipment service documentation, normal use typically refers to standard field operation as opposed to severe-duty cycles involving extreme loads, contaminated environments, or extended high-stress operation.

Other Systems