Deutz-Fahr C 6000

Brake fluid capacity & service interval

Deutz-Fahr C 6000 uses brake fluid with a capacity of 0,3 liter. The service interval for checking the fluid is 50 hours. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
C6205, Stage IIIB/Tier 4 (2017- )
  • Use: Normal
  • Capacity 0,3 liter
  • Check 50 hours
C6205 TS, Stage IIIB/Tier 4 (2017- )
  • Use: Normal
  • Capacity 0,3 liter
  • Check 50 hours
C6205 (2016- )
  • Use: Normal
  • Capacity 0,3 liter
  • Check 50 hours
C6205 TS (2016- )
  • Use: Normal
  • Capacity 0,3 liter
  • Check 50 hours

Additional Notes

  • The Deutz-Fahr C 6000 hydraulic brake system holds 0.3 liter across all four listed configurations, a relatively small reservoir volume consistent with a dedicated brake fluid circuit rather than a shared hydraulic system.
  • A 50-hour check interval applies to the hydraulic brake system on every listed configuration, reflecting a normal use condition service schedule tied to operational hours rather than calendar time.
  • The C6205 and C6205 TS configurations both carry a 2016 starting year, while the Stage IIIB/Tier 4 variants of each are listed from 2017 onward, marking the introduction of the emissions-compliant engine variants one year later.
  • Stage IIIB/Tier 4 designations refer to exhaust emissions standards, and despite the difference in engine certification between the standard and Stage IIIB/Tier 4 variants, the brake fluid capacity of 0.3 liter and the 50-hour check interval remain identical across all four configurations.
  • The 0.3-liter capacity figure represents a service fill level for the hydraulic brake system reservoir, not an overhaul or full system flush volume, indicating the specification is intended for routine fluid level maintenance.

Other Systems