Deutz-Fahr Agrotron K

Additional Notes

• The Deutz-Fahr Agrotron K transaxle fluid capacity is listed as a range of 42 to 45 liters across all variants. A range rather than a fixed value typically reflects minor differences in fill level depending on assembly tolerances or measurement method, rather than a distinction between service fill and overhaul fill.
• All variants share an identical normal-use check interval of every 250 hours. In agricultural equipment, periodic fluid level checks at this frequency serve to catch leaks or consumption between full drain-and-fill service events.
• Under normal use conditions, the fluid change interval is set at 1000 hours or 12 months, whichever comes first. The dual trigger means calendar time governs the interval even when annual operating hours fall short of 1000.
• An initial service condition is specified separately from normal use for all variants. At initial service, the change interval is halved to 500 hours or 12 months. This earlier first change is standard practice for mechanical transmissions, as break-in wear generates fine metallic particles that contaminate fresh fluid during the first period of operation.
• The initial service entries carry no check interval, unlike the normal-use entries which include a 250-hour check. The absence of a separate check step in the initial service schedule reflects that the fluid change itself occurs early enough to serve as the primary inspection point.
• The K90, K100, K110, and K120 variants all share the same 42-45 liter capacity and the same hour-based intervals, indicating a common transaxle unit across the Agrotron K range regardless of power output differences implied by the model designations.
• Profiline variants of the K90, K100, K110, and K120 carry production years of 2007-2013, one year later than the standard variants which begin in 2006. Despite the later introduction, Profiline models share identical fluid capacities and service intervals with their standard counterparts.