Deutz-Fahr Agrosun

Manual transmission fluid capacity & service interval

Deutz-Fahr Agrosun manual transmission fluid capacity is 76 liters. Service intervals include checking at 150 hours and changing at 2400 hours. The data covers 3 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Agrosun 100 (2001-2010)
  • Use: Normal
  • Capacity 76 liter
  • Check 150 hours
  • Change 2400 hours
Agrosun 120 (2001-2010)
  • Use: Normal
  • Capacity 76 liter
  • Check 150 hours
  • Change 2400 hours
Agrosun 140 (2001-2010)
  • Use: Normal
  • Capacity 76 liter
  • Check 150 hours
  • Change 2400 hours

Additional Notes

  • The Deutz-Fahr Agrosun transaxle manual transmission fluid capacity is 76 liters across the 100, 120, and 140 variants for the 2001-2010 model years, which is a substantial fill volume consistent with integrated transaxle assemblies that combine the gearbox, rear axle, and hydraulic functions into a single shared sump.
  • A 76-liter capacity in an agricultural transaxle system indicates a service fill specification rather than a dry or overhaul fill, meaning the figure reflects the working fluid volume maintained during normal operation rather than a complete drain-and-refill from an empty state.
  • The fluid check interval is set at 150 hours across all three variants, a relatively short interval by agricultural standards that reflects the importance of monitoring fluid level and condition in a high-load transaxle environment before committing to a full change cycle.
  • The fluid change interval is specified at 2400 hours under normal use conditions for the Agrosun 100, 120, and 140, which at typical agricultural usage rates of several hundred hours per season represents a multi-year service cycle.
  • The normal use condition tied to the 2400-hour change interval applies uniformly across all three power variants, indicating no differentiation in fluid service life expectations between the 100, 120, and 140 despite their differing engine outputs.
  • The ratio between the check interval of 150 hours and the change interval of 2400 hours means a fluid level inspection is performed approximately 16 times before a full fluid change is due, reflecting a maintenance approach that prioritizes ongoing monitoring over frequent fluid replacement.

Other Systems