Deutz-Fahr Agroplus S COM3

Power steering fluid capacity & service interval

Deutz-Fahr Agroplus S COM3 requires power steering fluid with a capacity of 41 liters. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Agroplus 320 S, Stage 3A ->1001 (2010-2016)
  • Transaxle/hydraulic system
  • Use: Normal
  • Capacity 41 liter
  • Agroplus 320 S, Stage 3A 1002->5001 (2009-2016)
  • Transaxle/hydraulic system
  • Use: Normal
  • Capacity 41 liter
  • Agroplus 410 S, Stage 3A ->1001 (2009-2016)
  • Transaxle/hydraulic system
  • Use: Normal
  • Capacity 41 liter
  • Agroplus 410 S, Stage 3A 1002->5001 (2009-2016)
  • Transaxle/hydraulic system
  • Use: Normal
  • Capacity 41 liter
  • Agroplus 420 S, Stage 3A ->1001 (2009-2016)
  • Transaxle/hydraulic system
  • Use: Normal
  • Capacity 41 liter
  • Agroplus 420 S, Stage 3A 1002->5001 (2009-2016)
  • Transaxle/hydraulic system
  • Use: Normal
  • Capacity 41 liter

Additional Notes

  • Across all Deutz-Fahr Agroplus S COM3 variants listed, the power steering fluid capacity is specified at 41 liters. A figure of this size reflects a shared reservoir arrangement where the transaxle, hydraulic system, and power steering all draw from a single common fluid volume rather than separate dedicated reservoirs.
  • The 41-liter capacity applies uniformly to the Agroplus 320 S, 410 S, and 420 S variants, covering both serial number ranges (up to 1001 and 1002 through 5001) across the 2009-2016 model years. No variation in capacity exists between any of these configurations.
  • Serial number breakpoints, such as the split between units up to 1001 and units from 1002 through 5001, are a common manufacturer method for distinguishing production batches that may have received engineering revisions. In these specifications, both serial number ranges share the same 41-liter capacity figure.
  • All six rows carry a normal use condition designation. In service specification contexts, a normal use condition typically corresponds to standard operating environments, as opposed to severe duty cycles that might involve extreme temperatures, heavy loads, or unusually frequent fluid contamination.
  • The Agroplus 320 S serial range up to 1001 carries a start year of 2010, while all other variants in the listing begin in 2009. All variants share the same 2016 end year within these specifications.
  • The Stage 3A designation refers to EU Stage IIIA emissions compliance, a regulatory tier applied to non-road mobile machinery engines. All variants listed fall under this emissions classification, which was a prevailing standard for agricultural tractors during the 2009-2016 period covered here.

Other Systems