Deutz-Fahr AgroFarm C

Differential fluid capacity & service interval

Deutz-Fahr AgroFarm C differential fluid capacity is 6 liters. Service intervals include checking at 300 hours and changing at 1200 hours or 24 months. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Agrofarm 100 C, ->ZKDT560200TD10001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Agrofarm 75 C, ->70001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Agrofarm 80 C, ->ZKDT500200TD10001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Agrofarm 85 C, ->70001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Agrofarm 90 C, ->ZKDT530200TD10001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Agrofarm 95 C, ->70001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months

Additional Notes

  • The front differential fluid capacity across all six Deutz-Fahr AgroFarm C variants — the 75 C, 80 C, 85 C, 90 C, 95 C, and 100 C — is uniformly specified at 6 liters. A consistent capacity figure across a range of power outputs suggests a shared front axle assembly rather than axle hardware scaled to engine size.
  • The check interval is set at every 300 hours under normal use conditions. In agricultural equipment, a 300-hour fluid check interval is a relatively frequent inspection point, reflecting the demanding load cycles and contamination exposure typical of front axle differentials in field operation.
  • The fluid change interval is specified at 1200 hours or 24 months, whichever comes first. The dual-trigger structure means a tractor used lightly enough to reach 24 months before accumulating 1200 hours would still require a fluid change on the calendar schedule alone.
  • The ratio of check interval to change interval is 4:1, meaning the fluid level and condition are inspected four times between each full drain-and-fill service. This staged approach allows early detection of leaks or contamination without the cost and downtime of a full fluid change at each inspection.
  • All six configurations carry serial number cutoff designations (e.g., "->ZKDT560200TD10001" or "->70001"), indicating the specifications apply to units produced up to those serial numbers within the 2014-2018 production window. Serial number boundaries are commonly used when a mid-production design revision changes a component specification.

Other Systems