Case - IH Axial-Flow, 40 Series

Automatic transmission fluid capacity & service interval

Case - IH Axial-Flow, 40 Series requires 20 liters of automatic transmission fluid. Service intervals include checking at 100 hours and changing at 600 hours. The data covers 3 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Axial-Flow 5140 (2013-2021)
  • Hydrostatic
  • Use: Normal
  • Capacity 20 liter
  • Check 100 hours
  • Change 600 hours
  • Axial-Flow 6140 (2013-2021)
  • Hydrostatic
  • Use: Normal
  • Capacity 20 liter
  • Check 100 hours
  • Change 600 hours
  • Axial-Flow 7140 (2013-2021)
  • Hydrostatic
  • Use: Normal
  • Capacity 20 liter
  • Check 100 hours
  • Change 600 hours

Additional Notes

  • The Case-IH Axial-Flow 40 Series covers three models in the transmission and hydrostatic fluid specifications: the 5140, 6140, and 7140, each spanning the 2013-2021 model years.
  • All three models share an identical fluid capacity of 20 liters for the combined transmission and hydrostatic system, a figure that reflects a service fill volume rather than a full overhaul or dry-fill quantity.
  • The check interval is set at 100 hours of operation under normal use conditions across the 5140, 6140, and 7140, which in agricultural equipment terms represents a relatively frequent inspection cycle tied to the demands of field operation.
  • The fluid change interval for all three models is 600 hours under normal use conditions, meaning six complete check cycles pass before a full fluid replacement is due.
  • The uniformity of capacity and interval figures across the 5140, 6140, and 7140 indicates a shared transmission and hydrostatic architecture among the three models within the 40 Series lineup for the 2013-2021 period.

Other Systems