Volvo VT series (USA / CAN)
Manual transmission fluid capacity & service interval
Volvo VT series (USA / CAN) manual transmission fluid has a capacity range of 11 to 13 liters. Service intervals include 96000 km/12 months, 500 hours/12 months, 800000 km/60 months, 60 months/2000 hours, and 800000 km. The data covers 30 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| VT 830 (2005-2007) |
|
| VT 830 (2005-2007) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| VT 880 (2005-2007) |
|
| VT 880 (2005-2007) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| VT Daycab (2005-2007) |
|
| VT Daycab (2005-2007) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Additional Notes
- Across the Volvo VT series (USA / CAN) 2005-2007, standard manual transmissions without a speed-count designation carry a fluid capacity of 12 liters, while 10/13/15/18-speed manual transmissions require 13 liters. The additional liter reflects the greater number of gear sets and internal passages in higher-range gearboxes.
- Automated manual transmissions in the 12-speed configuration hold 11 liters, and the 16-speed variant holds 11.83 liters. These values are lower than the 12- and 13-liter figures for conventional manual units, which is consistent with automated manual designs that integrate electronic actuators and may route fluid differently through the housing.
- The 96,000 km or 12-month change interval for standard manual transmissions under normal use conditions applies equally to the VT 830, VT 880, and VT Daycab across 2005-2007. Whichever limit is reached first triggers the service, making the calendar interval relevant for low-mileage operation.
- Under vocational use conditions, the change interval for standard manual transmissions shifts from a distance-based trigger to 500 hours or 12 months. Hour-based intervals are common in applications where the vehicle operates at low road speeds or in stationary power-takeoff modes, where odometer readings would underrepresent actual transmission workload.
- Automated manual transmissions under long-distance use conditions carry an 800,000 km or 60-month change interval. The 800,000 km figure represents an extended drain interval typical of modern synthetic-fill automated transmissions in highway freight applications, where consistent operating temperatures and reduced gear-shift shock reduce fluid degradation rates.
- For automated manual transmissions under vocational use, the interval is defined as 60 months or 2,000 hours, with no distance component. The 2,000-hour threshold replaces the 800,000 km figure, reflecting that vocational duty cycles accumulate operating hours far faster relative to distance traveled.
- The 12-speed and 16-speed automated manual variants under long-distance use list only an 800,000 km change interval, without a parallel month-based limit. The absence of a calendar component in those rows contrasts with the 60-month pairing seen in other automated manual entries.
- The 13-liter capacity for 10/13/15/18-speed manual transmissions applies under both normal and vocational use conditions across all three VT variants. The capacity value does not change between use conditions, meaning the fluid volume is a fixed mechanical property of the gearbox rather than a service-condition variable.