Gilera SMT / RCR

Brake fluid capacity & service interval

Gilera SMT / RCR uses brake fluid with a capacity range between min and max. Service intervals include checks at 1000 km and 5000 km, with a change interval of 24 months. The data covers 2 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
SMT/RCR (2007- )
  • Use: Normal
  • Between min and max.
  • Check 5000 km
  • Change 24 months
SMT/RCR (2007- )
  • Use: Initial service
  • Between min and max.
  • Check 1000 km

Additional Notes

  • The Gilera SMT / RCR hydraulic brake system does not carry a fixed fluid volume figure. The specification calls for a fill level between the minimum and maximum marks on the reservoir, which is the standard method for brake fluid servicing rather than a measured capacity fill.
  • Under normal use conditions, the brake fluid level on the SMT / RCR is scheduled for inspection at every 5000 km interval.
  • A separate initial service check interval of 1000 km applies to the hydraulic brake system, reflecting the early-life inspection that follows break-in of new brake components.
  • The normal use condition also carries a time-based fluid replacement interval of 24 months, independent of distance traveled. Brake fluid absorbs moisture over time, which lowers its boiling point, so calendar-based replacement addresses degradation that mileage intervals alone would not capture.
  • The initial service row specifies only a 1000 km check interval and does not include a fluid change interval, distinguishing it from the normal use schedule which carries both a distance-based check and a time-based replacement requirement.

Other Systems