Nissan Primastar, X82 (EU)

Coolant capacity & service interval

Nissan Primastar, X82 (EU) coolant capacity ranges from 13,4 to 13,7 liters. Service intervals consist of 150000 km or 72 months and 160000 km or 72 months. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Primastar 2.0 dCi (110 kW) DPF Euro 6d (2021- )
  • Use: Normal
  • Capacity 13,7 liter
  • Change 150000 km/ 72 months
Primastar 2.0 dCi (125 kW) DPF Euro 6d (2021- )
  • Use: Normal
  • Capacity 13,4 liter
  • Change 160000 km/ 72 months
Primastar 2.0 dCi (81 kW) DPF Euro 6d (2021- )
  • Use: Normal
  • Capacity 13,7 liter
  • Change 150000 km/ 72 months
Primastar 2.0 dCi (96 kW) DPF Euro 6d (2021- )
  • Use: Normal
  • Capacity 13,7 liter
  • Change 150000 km/ 72 months

Additional Notes

  • The Nissan Primastar X82 cooling system capacity varies by engine output. The 110 kW, 81 kW, and 96 kW variants of the 2.0 dCi share a 13.7-liter cooling system capacity, while the 125 kW variant holds a slightly smaller 13.4 liters.
  • A cooling system capacity figure represents the total volume of coolant the entire system holds, including the engine block, cylinder head, radiator, heater core, and associated hoses. A full drain and refill during a service typically recovers less than the stated capacity unless a vacuum fill method is used.
  • All four 2.0 dCi Euro 6d engine variants share a 72-month coolant change interval under normal use conditions, equivalent to a six-year service cycle regardless of mileage accumulation.
  • The distance-based change interval differs between engine outputs. The 110 kW, 81 kW, and 96 kW variants carry a 150,000 km mileage threshold, whereas the 125 kW variant is specified at 160,000 km.
  • Normal use conditions, as referenced in these specifications, apply to all four engine variants without a separate severe-use interval listed. The 150,000 km and 160,000 km figures therefore reflect standard operating expectations rather than reduced-duty cycles.
  • All listed engines carry a DPF designation, indicating a diesel particulate filter is fitted as part of Euro 6d emissions compliance. Cooling system capacity figures in such configurations can reflect additional thermal management requirements associated with DPF regeneration cycles.
  • The 0.3-liter difference in cooling system capacity between the 125 kW variant and the remaining three variants, despite all sharing the same 2.0-liter dCi engine family, suggests a difference in cooling circuit configuration or component sizing at the higher power output level.

Other Systems