Iveco Daily 38
Brake fluid capacity & service interval
Iveco Daily 38 uses brake fluid with a capacity of 1,11 liters. The service interval for the fluid is 24 months. The data covers 6 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| Daily 38 S 12 (2024- ) |
|
| Daily 38 S 14 (2024- ) |
|
| Daily 38 S 16 (2024- ) |
|
| Daily 38 S 16 3.0 (2024- ) |
|
| Daily 38 S 18 (2024- ) |
|
| Daily 38 S 21 (2024- ) |
|
Additional Notes
- All six variants of the Iveco Daily 38 covered in these specifications share an identical hydraulic brake system capacity of 1.11 liters, indicating a uniform brake circuit volume across the entire 38 S range regardless of engine output designation.
- The 1.11-liter figure represents a service fill capacity for the hydraulic brake system, reflecting the total fluid volume held within the lines, master cylinder, and calipers or wheel cylinders under normal operating conditions.
- A 24-month change interval applies uniformly across all six variants under normal use conditions, meaning the fluid replacement cycle is tied to elapsed time rather than distance traveled or operating load.
- Time-based brake fluid intervals exist because brake fluid is hygroscopic, absorbing moisture from the atmosphere over time regardless of mileage, which gradually lowers the fluid's boiling point and can compromise hydraulic performance.
- The specifications cover variants spanning a range of output designations, from the 38 S 12 through to the 38 S 21, yet the brake system capacity and change interval remain consistent across all of them, pointing to a shared hydraulic architecture within the Daily 38 platform for the 2024 generation.
- The Daily 38 S 16 appears in two separate entries, one without an engine displacement designation and one identified as the 3.0, both sharing the same 1.11-liter capacity and 24-month interval under normal use conditions.