Hino Dutro / 300 series Euro 4
Manual transmission fluid capacity & service interval
Hino Dutro / 300 series Euro 4 manual transmission fluid capacity ranges from 2,8 to 3,8 liters. The data covers 2 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| 300 Euro 4, 3616 (2007- ) |
|
| 300 Euro 4, 3616 (2007- ) |
|
Additional Notes
- The Hino Dutro / 300 series Euro 4 in the 3616 configuration carries two distinct manual transmission fluid capacities: one ranging from 2.8 to 3.1 liters and another ranging from 3.5 to 3.8 liters, indicating two separate transmission units are fitted across variants of the same model designation.
- A capacity expressed as a range rather than a fixed value typically reflects manufacturing tolerances or minor differences in how fluid settles during a drain-and-fill service, meaning the lower figure represents a minimum acceptable fill and the upper figure the maximum.
- Both capacity entries are assigned a normal use condition, meaning the intervals and fill quantities listed apply to standard operating environments rather than severe-duty cycles such as frequent towing, extreme temperatures, or stop-and-go urban routes.
- The 3616 designation applies to the 3616 configuration starting from 2007, and both fluid capacity ranges are associated with that same year of introduction.
- The difference between the two capacity ranges, approximately 0.7 liters at the midpoint of each, is consistent with the kind of variation seen between a lighter-duty and a heavier-duty gearbox sharing the same platform, where a larger unit requires a greater fluid volume to maintain adequate lubrication across all gear sets and bearings.