Freight Rover Sherpa 200-300
Coolant capacity & service interval
Freight Rover Sherpa 200-300 uses coolant with a capacity range of 6,55 to 8,25 liters. Service intervals occur every 40000 km or 48 months. The data covers 3 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| Sherpa 200-300 1.7 (1986-1988) |
|
| Sherpa 200-300 2.0 (1986-1988) |
|
| Sherpa 200-300 2.5 D (1984-1988) |
|
Additional Notes
- The Freight Rover Sherpa 200-300 1.7 and 2.0 petrol engines share an identical cooling system capacity of 6.55 liters, indicating a common cooling circuit design across both engine displacements for the 1986-1988 model years.
- The 2.5 D diesel variant carries a notably larger cooling system capacity of 8.25 liters, which is approximately 26 percent greater than the 6.55-liter figure recorded for the 1.7 and 2.0 engines, reflecting the higher thermal load typically associated with diesel combustion cycles.
- A service fill capacity, as opposed to a dry or overhaul fill, generally accounts for residual fluid retained in the system during a drain. The 6.55-liter and 8.25-liter figures here represent the total cooling system volume rather than a partial top-up quantity.
- All three engine configurations share the same change interval of 40,000 km or 48 months under normal use conditions, meaning the interval applies to standard operating environments rather than severe or extended-duty cycles.
- The 48-month time limit on the coolant change interval reflects the chemical degradation of antifreeze inhibitors over time, which occurs independently of mileage accumulation.
- The 2.5 D diesel is the only engine among the three with specifications covering the full 1984-1988 span, while the 1.7 and 2.0 petrol engines carry specifications beginning from 1986.