Linde Container handlers (318 series)

Coolant capacity & service interval

Linde Container handlers (318 series) require 20 liters of coolant. Service intervals include checking every 10 hours and changing every 2000 hours. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
C90/5, Cummins QSB6.7
  • Use: Normal
  • Capacity 20 liter
  • Check 10 hours
  • Change 2000 hours
C90/6, Cummins QSB6.7
  • Use: Normal
  • Capacity 20 liter
  • Check 10 hours
  • Change 2000 hours
C90/7, Cummins QSB6.7
  • Use: Normal
  • Capacity 20 liter
  • Check 10 hours
  • Change 2000 hours
C90/8, Cummins QSB6.7
  • Use: Normal
  • Capacity 20 liter
  • Check 10 hours
  • Change 2000 hours

Additional Notes

  • All four configurations in the Linde Container Handlers (318 series) covered here share an identical cooling system capacity of 20 liters, which is consistent with the Cummins QSB6.7 engine used across the C90/5, C90/6, C90/7, and C90/8 variants.
  • The Cummins QSB6.7 is a 6.7-liter inline six-cylinder diesel engine, and a 20-liter cooling system capacity reflects the total volume of the circuit including the engine block, cylinder head passages, radiator, hoses, and reservoir rather than the engine alone.
  • Coolant checks are specified at every 10 hours of operation under normal use conditions, placing the interval among the most frequent service tasks on the machine and reflecting the critical role coolant level plays in preventing engine overheating.
  • The coolant change interval is set at 2000 hours under normal use conditions, a figure that aligns with extended-life coolant formulations commonly specified for industrial diesel engines operating in controlled environments.
  • The check and change intervals are both tied to normal use conditions, meaning operation in environments without exceptional heat, dust, or load stress that would otherwise shorten service cycles.
  • The capacity figure of 20 liters is uniform across the C90/5, C90/6, C90/7, and C90/8 despite the differing numeric designations, indicating the cooling circuit architecture does not vary between these configurations even as other machine specifications may differ.