Bomag Soil stabilizers/asphalt recyclers, MPH
Transfer case fluid capacity & service interval
Bomag Soil stabilizers/asphalt recyclers, MPH transfer case fluid capacity is 8 liters. Service intervals include checks at 10 hours and changes at 250, 500, or 2000 hours, or 24 months. The data covers 3 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| MPH-125, Deutz TCD2015 V08 (S/N 101 590 20 ...->) (2006- ) |
|
| MPH-125, Deutz TCD2015 V08 (S/N 101 590 20 ...->) (2006- ) |
|
| MPH-125, Deutz TCD2015 V08 (S/N 101 590 20 ...->) (2006- ) |
|
Additional Notes
- The Bomag MPH-125 with Deutz TCD2015 V08 engine, covering serial numbers from 101 590 20 onward starting in 2006, carries a transfer case fluid capacity of 8 liters across all three service conditions listed.
- The 8-liter figure applies consistently whether the interval is an initial service, a second change, or a normal recurring service, indicating a full drain-and-fill volume rather than a partial top-up quantity.
- Under normal use conditions, the transfer case fluid level is subject to a check interval of every 10 hours, which reflects the demanding operating environment typical of soil stabilization and asphalt recycling equipment.
- The normal-use change interval is set at 2000 hours or 24 months, whichever comes first, meaning both an operational threshold and a calendar threshold govern when a fluid change is due.
- An initial service change is specified at 250 hours, a significantly shorter interval than the 2000-hour normal cycle, consistent with the practice of removing break-in contaminants and metal particles generated during early component wear.
- A second change interval is separately defined at 500 hours, placing an additional fluid exchange between the 250-hour initial service and the 2000-hour recurring cycle before the standard schedule takes over.