Volvo V60, 155 (USA / CAN)

Coolant capacity & service interval

Volvo V60, 155 (USA / CAN) coolant capacity ranges from 8,3 to 8,9 liters. Service intervals require checks every 10000 miles or 12 months. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
V60 2.0 T5 AWD (2016-2018)
  • Use: Normal
  • Capacity 8,3 liter
  • Check 10000 miles/ 12 months
V60 2.0 T6 AWD (2016-2018)
  • Use: Normal
  • Capacity 8,3 liter
  • Check 10000 miles/ 12 months
V60 2.0 T5 (2015-2018)
  • Use: Normal
  • Capacity 8,3 liter
  • Check 10000 miles/ 12 months
V60 2.0 T6 (2015-2017)
  • Use: Normal
  • Capacity 8,3 liter
  • Check 10000 miles/ 12 months
V60 2.5 T5 AWD (2014-2016)
  • Use: Normal
  • Capacity 8,9 liter
  • Check 10000 miles/ 12 months
V60 3.0 T6 AWD (2014-2016)
  • Use: Normal
  • Capacity 8,9 liter
  • Check 10000 miles/ 12 months

Additional Notes

  • Across all six configurations of the Volvo V60 155 covered here, the cooling system check interval is set at 10,000 miles or 12 months under normal use conditions, whichever comes first.
  • The 2.0-liter four-cylinder engines, spanning both the T5 and T6 variants from 2015 onward, share a uniform cooling system capacity of 8.3 liters. This figure represents the total system fill volume, encompassing the engine block, cylinder head passages, radiator, heater core, and expansion tank.
  • The 2.5 T5 AWD and 3.0 T6 AWD configurations, both covering 2014-2016, carry a larger cooling system capacity of 8.9 liters. The additional 0.6 liters relative to the 2.0-liter engines reflects the greater coolant volume required by the larger displacement inline-five and inline-six architectures.
  • The AWD variant of the 2.0 T5 begins in 2016, two model years after the 2.5 T5 AWD was introduced in 2014, and shares the same 8.3-liter capacity as the front-wheel-drive 2.0 T5 despite the added drivetrain hardware.
  • The 2.0 T6 AWD runs from 2016-2018 and holds the same 8.3-liter capacity as the non-AWD 2.0 T6, which covers 2015-2017, indicating the AWD system on the 2.0-liter platform does not alter the cooling circuit volume.
  • A cooling system capacity listed as a service fill value, as seen in all rows here, reflects the amount of coolant needed to refill a fully drained system and is distinct from a partial top-up volume, which would be considerably lower.

Other Systems