Volkswagen (VW) Corrado (EU)
Manual transmission fluid capacity & service interval
Volkswagen Corrado (EU) manual transmission fluid capacity is 2 liter. Service intervals consist of checks every 15000 km or 12 months. The data covers 6 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| Corrado 2.0i (1993-1995) |
|
| Corrado 2.0i 16V (1992-1995) |
|
| Corrado 2.8 VR6 (1992-1995) |
|
| Corrado 2.9 VR6 (1992-1995) |
|
| Corrado 1.8i 16V (1988-1992) |
|
| Corrado 1.8i G60 (1988-1993) |
|
Additional Notes
- Across all Volkswagen Corrado (EU) engine variants from 1988-1995, the manual transaxle fluid capacity is uniformly 2 liters. A transaxle combines the transmission and differential into a single housing, and a 2-liter fill capacity is consistent with the compact integrated units commonly found in front-wheel-drive sport coupes of this era.
- The Corrado 1.8i G60 is the only variant in the lineup with a specified fluid check interval, set at every 15,000 km or 12 months under normal use conditions. A check interval differs from a change interval in that it requires inspecting the fluid level and condition rather than replacing the fluid outright.
- The normal use condition applies to all six variants listed. In fluid service terminology, normal use typically refers to standard driving patterns without the added thermal or mechanical stress associated with severe use classifications such as towing, frequent short trips, or extreme temperatures.
- The 1.8i 16V covers model years 1988-1992, while the 1.8i G60 spans 1988-1993. Both share the same 2-liter transaxle capacity despite differing in engine configuration, with the G60 designation referring to a supercharged variant using a scroll-type compressor.
- The 2.0i and 2.0i 16V variants overlap in production years 1993-1995 and 1992-1995 respectively, representing two distinct 2.0-liter engine configurations. The 16V designation indicates a twin-cam, four-valves-per-cylinder head, while the base 2.0i uses a single-cam layout, yet both share the same 2-liter transaxle fill specification.
- The VR6 variants, listed as 2.8 and 2.9 displacements for 1992-1995, both carry the same 2-liter transaxle capacity as the four-cylinder models. The VR6 is a narrow-angle six-cylinder engine configuration developed by Volkswagen, and its fitment in the Corrado did not alter the transaxle fluid volume requirement relative to the smaller-displacement variants.