Volkswagen (VW) CC, 358 (USA / CAN)
Transfer case fluid capacity & service interval
Volkswagen CC, 358 (USA / CAN) requires transfer case fluid with a capacity of 0,9 liter. The data covers 2 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
|
|
|
|
Additional Notes
- The Volkswagen CC 358 in the 3.6 V6 FSI 4Motion configuration carries a transfer case fluid capacity of 0.9 liter, which is a relatively small volume consistent with the compact internal dimensions typical of an angle gearbox or transferbox unit in a passenger car all-wheel-drive system.
- Both the 2011-2013 and 2013-2016 variants of the CC 3.6 V6 FSI 4Motion share an identical 0.9 liter capacity figure for the angle gearbox, indicating no change in the transferbox design between those two production periods despite the model year split in the specifications.
- The capacity listed in both rows represents a service fill volume, meaning the amount of fluid the unit holds under normal operating conditions rather than a dry or overhaul fill, which would typically be a higher figure accounting for residual fluid in passages and cooler lines.
- The use condition recorded for both configurations is normal, and under that condition no service interval mileage or time value is listed alongside the 0.9 liter capacity, meaning the specifications address fluid volume without pairing a drain-and-refill schedule to the normal use designation.
- The angle gearbox notation present in both rows identifies the transferbox as a bevel-gear-type unit, a design commonly used to redirect torque from a longitudinally mounted drivetrain to a rear axle, which is consistent with the 4Motion all-wheel-drive architecture found on the CC 3.6 V6 FSI.