Skoda 1200 series
Brake fluid capacity & service interval
The Skoda 1200 series uses brake fluid with a capacity of 0.75 kg or 0.6 liter, depending on the configuration. The data covers 3 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| 1202, 981 (1961-1972) |
|
| 1201, 980 (1956-1961) |
|
| 1200, 955 (1952-1956) |
|
Additional Notes
- The Skoda 1200 series spans three distinct model generations across the 1952-1972 period, each carrying its own brake fluid capacity specification for the hydraulic brake system.
- The 1200 and 955 models from 1952-1956 list a brake fluid capacity expressed in kilograms at 0.75 kg, rather than in volume units. A mass-based measurement of this kind reflects the density of the fluid being factored into the specification, which was a less standardized era of automotive service documentation.
- Starting with the 1201 and 980 from 1956-1961, the capacity shifts to a volume-based figure of 0.6 liter, representing a change in how the specification is expressed compared to the earlier 1200 and 955 generation.
- The 1202 and 981 models covering 1961-1972 share the same 0.6 liter capacity as the preceding 1201 and 980 generation, indicating continuity in the hydraulic brake system volume across those two generations.
- All three generations carry a normal use condition tied to their respective capacity figures, meaning the listed volumes apply to standard operating conditions rather than severe or first-change scenarios.
- The 0.75 kg figure for the 1952-1956 models represents the largest brake fluid quantity across the three generations when accounting for fluid density, as 0.75 kg of typical brake fluid at roughly 1.05 g/ml would correspond to approximately 0.71 liters, exceeding the 0.6 liter figure of the later models.