Lamborghini Countach

Differential fluid capacity & service interval

Lamborghini Countach differential fluid capacity ranges from 0,8 liter to 2 liter. Service intervals include checks at 15000 km and changes at 2500 km, 30000 km, or 24 months. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Countach LPI 800-4 (2021-2022)
  • Front
  • Use: Normal
  • Capacity 0,8 liter
  • Check 15000 km
  • Change 30000 km/ 24 months
  • Countach LPI 800-4 (2021-2022)
  • Front
  • Use: First change only
  • Capacity 0,8 liter
  • Change 2500 km
  • Countach LPI 800-4 (2021-2022)
  • Rear
  • Use: Normal
  • Capacity 2 liter (Dry fill)
  • Capacity 1,3 liter (Service fill)
  • Check 15000 km
  • Change 30000 km/ 24 months
  • Countach LPI 800-4 (2021-2022)
  • Rear
  • Use: First change only
  • Capacity 2 liter (Dry fill)
  • Capacity 1,3 liter (Service fill)
  • Change 2500 km

Additional Notes

  • The Lamborghini Countach LPI 800-4 front differential holds 0.8 liter, a single capacity value that applies to both routine service and initial fill situations.
  • The rear differential on the LPI 800-4 lists two distinct capacity values: 2 liters for a dry fill and 1.3 liters for a service fill. The dry fill figure reflects the total volume needed when the unit is completely empty, such as after a rebuild or replacement, while the service fill figure reflects the smaller volume required during a standard fluid change when residual fluid remains in the housing.
  • Under normal use conditions, both the front and rear differentials share the same inspection interval of 15,000 km, meaning fluid level verification is expected at that mileage point before a full change is due.
  • The normal-use change interval for both differentials is 30,000 km or 24 months, whichever comes first, introducing a time-based limit alongside the mileage threshold.
  • A first-change-only condition is specified separately for both the front and rear differentials, with a change interval of 2,500 km. A break-in change at low mileage is typically intended to remove metal particles and manufacturing residues that accumulate during initial component wear-in.
  • The first-change-only interval of 2,500 km applies to both differentials equally, and no capacity difference is noted between the first change and subsequent normal-use changes for the front differential, which remains at 0.8 liter in both rows.
  • For the rear differential under the first-change-only condition, the same dry fill and service fill values of 2 liters and 1.3 liters are listed, indicating the capacity distinction carries over regardless of whether the change is an initial break-in service or a routine interval.

Other Systems