Jeep MB / GPW
Manual transmission fluid capacity & service interval
Jeep MB / GPW manual transmission fluid capacity is 0,71 liter. Service intervals occur every 10000 km. The data covers 2 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| Ford Model GPW (1941-1945) |
|
| Willys- Overland model MB (1941-1945) |
|
Additional Notes
- The Jeep MB / GPW manual transmission fluid capacity is 0.71 liter across both the Ford Model GPW and the Willys-Overland Model MB variants produced from 1941-1945. A capacity at this level is characteristic of a compact, light-duty gearbox, consistent with the small three-speed transmission units fitted to these vehicles.
- The 0.71 liter figure represents a service fill volume, meaning the amount of fluid used during a routine drain-and-refill service rather than a full overhaul rebuild quantity, which would typically account for additional fluid retained in passages and components.
- The Ford Model GPW and the Willys-Overland Model MB share an identical fluid capacity of 0.71 liter, reflecting the deliberate mechanical standardization between the two manufacturers, who produced functionally interchangeable vehicles under wartime procurement requirements.
- The specified change interval for both variants is 10,000 km under normal use conditions. Normal use, as a service classification, generally refers to operation within typical load, temperature, and duty-cycle parameters rather than sustained extreme or high-stress conditions.
- Both the GPW and MB specifications carry the same 10,000 km interval without a separate severe-use interval listed, and both are assigned the normal use condition designation for the transmission fluid change schedule.