Hongqi HS3

Automatic transmission fluid capacity & service interval

Hongqi HS3 automatic transmission fluid capacity ranges from 5,7 liters to 7,2 liters. The data covers 2 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • HS3 1.5T (2023- )
  • DCT
  • Use: Normal
  • Capacity 7,2 liter (Dry fill)
  • Capacity 5,7 liter (Service fill)
  • Code: 6/1
HS3 2.0T (2023- )
  • Use: Normal
  • Capacity 6,3 liter
  • Code: 8/1

Additional Notes

  • The Hongqi HS3 1.5T carries a dry fill capacity of 7.2 liters, which reflects the total fluid volume required when filling a completely drained or newly assembled transaxle where internal passages and the torque converter hold no residual fluid.
  • The 1.5T service fill capacity of 5.7 liters is the lower figure used during routine fluid changes, accounting for fluid that remains trapped in the transmission after a standard drain procedure.
  • The difference between the 1.5T dry fill and service fill figures — 1.5 liters — represents the volume of fluid that does not drain during a conventional service, a gap that is typical in dual-clutch transaxle designs where fluid is retained in clutch packs and internal galleries.
  • The 1.5T unit is noted as a semi-automatic DCT transaxle, meaning fluid management in normal use conditions applies to a dual-clutch design rather than a conventional torque-converter automatic.
  • The 2.0T variant uses a conventional automatic transaxle and carries a single listed capacity of 6.3 liters, with no separate dry fill figure provided in the specifications.
  • Both configurations are listed under normal use conditions, meaning the capacities recorded apply to standard operating environments rather than severe-duty cycles.

Other Systems