Honda CR-V III, RE (EU)

Transfer case fluid capacity & service interval

Honda CR-V III, RE (EU) transfer case fluid capacity ranges from 0,41 to 0,45 liters. Service intervals include 40000 km/48 months, 60000 km/48 months, 80000 km/48 months, and 120000 km/96 months. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
CR-V 2.2i-DTEC 4WD (2010-2011)
  • Use: Normal
  • Capacity 0,45 liter (Dry fill)
  • Capacity 0,41 liter (Service fill)
  • Change 80000 km/ 48 months
CR-V 2.2i-DTEC 4WD (2010-2011)
  • Use: Severe
  • Capacity 0,45 liter (Dry fill)
  • Capacity 0,41 liter (Service fill)
  • Change 40000 km/ 48 months
CR-V 2.2i-DTEC 4WD (2010-2011)
  • Use: First change only
  • Capacity 0,45 liter (Dry fill)
  • Capacity 0,41 liter (Service fill)
  • Change 120000 km/ 96 months
CR-V 2.2i-DTEC 4WD (2010-2011)
  • Use: First change only, severe
  • Capacity 0,45 liter (Dry fill)
  • Capacity 0,41 liter (Service fill)
  • Change 60000 km/ 48 months

Additional Notes

  • The Honda CR-V III, RE (EU) 2.2i-DTEC 4WD transferbox carries a dry fill capacity of 0.45 liter, which represents the total volume required when filling a completely drained or rebuilt unit from empty.
  • The service fill capacity of 0.41 liter is lower than the dry fill figure, reflecting the residual fluid that remains in the transferbox during a routine drain-and-refill procedure rather than a full overhaul.
  • Under normal use conditions, the transferbox fluid change interval is set at 80,000 km or 48 months, whichever comes first.
  • Under severe use conditions, the distance-based interval is reduced to 40,000 km, while the time-based limit remains at 48 months, meaning the calendar interval stays constant regardless of use severity.
  • A first-change-only interval of 120,000 km or 96 months applies to the 2010-2011 2.2i-DTEC 4WD transferbox, indicating a one-time extended service window before the standard recurring schedule takes effect.
  • When severe use conditions are combined with a first-change-only designation, the initial change interval is shortened to 60,000 km or 48 months, reflecting the combined effect of demanding operating conditions on the break-in fluid.

Other Systems