Ford Tourneo Connect, V761 (EU)

Manual transmission fluid capacity & service interval

Ford Tourneo Connect, V761 (EU) manual transmission fluid capacity ranges from 1,5 to 2,3 liters. Service intervals consist of checks every 24 months or 30000 km. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Tourneo Connect 1.5 Ecoboost (84 kW) PF (2021- )
  • Use: Normal
  • Capacity 1,5 liter
  • Code: SG6 6/1
Tourneo Connect 2.0 EcoBlue (75 kW) DPF (2021- )
  • Use: Normal
  • Capacity 1,5 liter
  • Code: SG6 6/1
Tourneo Connect 2.0 EcoBlue (90 kW) AWD DPF (2021- )
  • Use: Normal
  • Capacity 2,3 liter
  • Check 24 months/ 30000 km
  • Code: SG6 6/1
Tourneo Connect 2.0 EcoBlue (90 kW) DPF (2021- )
  • Use: Normal
  • Capacity 1,5 liter
  • Code: SG6 6/1

Additional Notes

  • The Ford Tourneo Connect V761 (EU) manual transaxle fluid capacity splits into two distinct values across the 2021 lineup: 1.5 liters for most configurations and 2.3 liters for the 2.0 EcoBlue 90 kW AWD DPF variant.
  • A 1.5-liter transaxle fill is shared by the 1.5 EcoBoost 84 kW PF, the 2.0 EcoBlue 75 kW DPF, and the 2.0 EcoBlue 90 kW DPF configurations, all under normal use conditions.
  • The 2.0 EcoBlue 90 kW AWD DPF transaxle holds 2.3 liters, which is 53% more fluid than the 1.5-liter figure seen in the non-AWD variants, reflecting the added mechanical complexity of an all-wheel-drive transaxle assembly.
  • A service check interval of 24 months or 30,000 km applies to the 2.0 EcoBlue 90 kW AWD DPF manual transaxle under normal use conditions. No equivalent interval is listed for the other three configurations.
  • All four configurations specify normal use conditions, meaning the listed capacities and, where present, the service interval apply to standard operating environments rather than severe-duty cycles.
  • The 2.3-liter capacity of the AWD transaxle is consistent with a service fill rather than a full overhaul figure, as it represents the working fluid volume maintained during routine fluid checks and top-ups rather than a complete drain-and-refill of a disassembled unit.

Other Systems