Daihatsu Cuore / Mira / Domino
Manual transmission fluid capacity & service interval
Daihatsu Cuore / Mira / Domino manual transmission fluid capacity ranges from 1,4 to 1,6 liters. Service intervals include checking every 10000 km or 6 months and changing every 40000 km or 24 months. The data covers 5 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| Cuore / Mira / Domino 850 (1990-1998) |
|
| Cuore / Mira / Domino 850 (1986-1990) |
|
| Cuore / Mira / Domino 850 (1986-1990) |
|
| Cuore / Mira / Domino (1981-1985) |
|
| Cuore / Mira / Domino (1978-1981) |
|
Additional Notes
- The Daihatsu Cuore / Mira / Domino transaxle manual fluid capacity held at 1.4 liters across the 1978-1985 model range, covering two consecutive generation spans without variation in the service fill volume.
- Starting with the 850 variant from 1986, the transaxle capacity increased from 1.4 liters to either 1.5 or 1.6 liters depending on configuration, marking a clear departure from the earlier generation fill volume.
- The 1986-1990 850 generation carries two distinct capacity figures — 1.5 liters and 1.6 liters — applied to the same transaxle, manual note, indicating a variation between specific drivetrain or trim configurations within that production span.
- The 1.6-liter transaxle fill volume established in the 1986-1990 850 generation carried forward unchanged into the 1990-1998 850 generation, making 1.6 liters the consistent service fill figure for the later production period.
- A transaxle fluid check interval of every 10,000 km or 6 months applies uniformly across all five specification rows, from the 1978-1981 generation through the 1990-1998 850 variant, with no deviation across any configuration.
- The fluid change interval of 40,000 km or 24 months is consistent across the entire 1978-1998 range covered in the specifications, applying equally under normal use conditions to every listed generation and capacity variant.
- All specifications across the full 1978-1998 range are designated for normal use conditions, meaning the check and change intervals listed reflect standard operating environments rather than severe or demanding service cycles.
- The check interval of 6 months and the change interval of 24 months reflect a 1-to-4 ratio between inspection frequency and fluid replacement frequency, a pattern maintained without exception across all listed configurations.