Dacia Duster, H79

Automatic transmission fluid capacity & service interval

Dacia Duster H79 uses automatic transmission fluid with capacities ranging from 1.7 to 6.3 liters depending on the configuration. Six configurations are covered in the data.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Duster 1.5 dCi 110 DPF (2011-2018)
  • Use: Normal
  • Capacity 1,7 liter
  • Code: DC4 6/1
Duster 1.5 dCi 110 DPF (2011-2018)
  • Use: Normal
  • Capacity 1,9 liter
  • Code: TS4 6/1
Duster 2.0 16V (2010- )
  • Use: Normal
  • Capacity 6 liter (Dry fill)
  • Capacity 3,5 liter (Service fill)
  • Code: DP2 4/1
Duster 2.0 16V AWD (2010- )
  • Use: Normal
  • Capacity 6,3 liter (Dry fill)
  • Capacity 3,8 liter (Service fill)
  • Code: DP8 6/1
Duster 2.0 16V Hi-Flex (2010- )
  • Use: Normal
  • Capacity 6 liter (Dry fill)
  • Capacity 3,5 liter (Service fill)
  • Code: DP2 4/1
Duster 2.0 16V Hi-Flex AWD (2010- )
  • Use: Normal
  • Capacity 6,3 liter (Dry fill)
  • Capacity 3,8 liter (Service fill)
  • Code: DP8 6/1

Additional Notes

  • The Dacia Duster H79 1.5 dCi 110 DPF carries two separate capacity figures for its semi-automatic transaxle under normal use conditions: 1.7 liters and 1.9 liters, covering the 2011-2018 model years.
  • The presence of two distinct capacity values for the 1.5 dCi 110 DPF semi-automatic transaxle suggests a variation between transmission variants or fill procedures, both of which fall within the same engine and model year range.
  • The 2.0 16V with a standard automatic transaxle carries a dry fill capacity of 6 liters, while the service fill capacity is 3.5 liters. The dry fill figure represents the total fluid volume of a fully drained or new unit, whereas the service fill reflects the smaller volume needed during a routine fluid change.
  • The 2.0 16V AWD automatic transaxle has a dry fill capacity of 6.3 liters and a service fill of 3.8 liters, both slightly higher than the non-AWD equivalent, reflecting the additional fluid demands of the all-wheel-drive transaxle assembly.
  • The 2.0 16V Hi-Flex automatic transaxle shares identical capacity figures with the standard 2.0 16V, at 6 liters dry fill and 3.5 liters service fill, indicating the flex-fuel engine variant does not alter the transmission fluid requirements.
  • The 2.0 16V Hi-Flex AWD automatic transaxle matches the non-flex AWD figures exactly, with a 6.3-liter dry fill and a 3.8-liter service fill, consistent with the AWD transaxle design rather than the engine fuel configuration driving the capacity difference.
  • Across all four 2.0 16V configurations, the service fill volume represents roughly 58-60% of the dry fill capacity, a ratio typical of automatic transaxles where a portion of fluid remains in the torque converter and passages even after draining.

Other Systems