Chrysler (Grand) Voyager / Town & Country, AS (USA / CAN)
Automatic transmission fluid capacity & service interval
Chrysler (Grand) Voyager / Town & Country, AS (USA / CAN) requires automatic transmission fluid with a capacity of 3,8 liters. The data covers 4 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| Town & Country 2.5 (USA), AS (1991-1995) |
|
| Town & Country 3.0 V6 (USA), AS (1991-1995) |
|
| Town & Country 3.3 V6 (USA), AS (1991-1995) |
|
| Town & Country 3.3 V6 AWD (USA), AS (1991-1995) |
|
Additional Notes
- Across all four Town & Country configurations spanning 1991-1995, the automatic transaxle fluid capacity is uniformly listed at 3.8 liters, covering the 2.5-liter four-cylinder, the 3.0 V6, the 3.3 V6, and the 3.3 V6 AWD variants.
- A capacity figure of 3.8 liters for an automatic transaxle typically represents a service fill, meaning the amount of fluid replaced during a routine drain and refill, rather than the total system capacity measured during a full overhaul with a dry unit.
- The Chrysler Town & Country 3.3 V6 AWD shares the same 3.8-liter transaxle service fill as the front-wheel-drive 3.3 V6, indicating the AWD system's additional drivetrain components are not reflected in the listed automatic transaxle capacity.
- All four configurations carry a normal use condition designation, meaning the 3.8-liter service fill applies specifically under standard operating conditions rather than severe-duty cycles.
- The identical 3.8-liter capacity across the 2.5-liter four-cylinder and both 3.3 V6 configurations suggests a shared transaxle unit was used across multiple engine displacements in the 1991-1995 Town & Country lineup.
- The 3.0 V6 is a Mitsubishi-sourced engine, yet the automatic transaxle fluid capacity for the 1991-1995 Town & Country 3.0 V6 matches the domestically engineered 3.3 V6 variants at 3.8 liters, pointing to transaxle commonality across engine origins.