Chery Tiggo / Tiggo 3
Automatic transmission fluid capacity & service interval
Chery Tiggo / Tiggo 3 automatic transmission fluid capacity is 6-6,5 liters. Service intervals include checking at 5000 km and changing at 100000 km. The data covers 2 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| Tiggo 2.4 (2008-2013) |
|
| Tiggo 2.0 (2006-2013) |
|
Additional Notes
- The Chery Tiggo / Tiggo 3 automatic transaxle carries a fluid capacity of 6 to 6.5 liters across both the 2.0 and 2.4 engine variants, a range that reflects typical fill tolerances in automatic transaxle servicing rather than a fixed single volume.
- The 0.5-liter spread in capacity between the lower and upper fill values is common in automatic transaxle specifications, where the final accepted volume depends on fluid temperature and the drain completeness achieved during a service fill versus a full overhaul procedure.
- The 2.0-liter variant, covering 2006-2013, carries a listed inspection interval of every 5,000 km under normal use conditions, which ties the fluid level check to a relatively frequent maintenance cycle by general automotive standards.
- A change interval of 100,000 km is specified for the Tiggo 2.0 automatic transaxle under normal use conditions, placing the fluid in a long-life service category that assumes consistent operating conditions without elevated thermal or load stress.
- The 2.4-liter variant, introduced for the 2008-2013 period, shares the same 6 to 6.5-liter capacity range as the 2.0, indicating the automatic transaxle unit used across both engine displacements holds an equivalent fluid volume.
- No check or change interval figures appear in the specifications for the Tiggo 2.4 automatic transaxle, meaning the only quantified servicing data available for that variant is the fluid capacity itself.