BMW Z4 Coupé, E86 (EU)

Manual transmission fluid capacity & service interval

BMW Z4 Coupé, E86 (EU) manual transmission fluid capacity ranges from 1,5 to 1,6 liters. The data covers 3 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Z4 Coupé 3.0si (2006-2008)
  • With MTF-LT2 label
  • Use: Normal
  • Capacity 1,6 liter (Initial fill)
  • Capacity 1,5 liter (Service fill)
  • Code: ZF GS6-37BZ/DZ 6/1
  • Z4 Coupé 3.0si (2006-2008)
  • With MTF-LT3 label
  • Use: Normal
  • Capacity 1,6 liter (Initial fill)
  • Capacity 1,5 liter (Service fill)
  • Code: ZF GS6-37BZ/DZ 6/1
  • Z4 M Coupé (2006-2008)
  • With MTF-LT3 label
  • Use: Normal
  • Capacity 1,6 liter (Initial fill)
  • Capacity 1,5 liter (Service fill)
  • Code: ZF GS6-37BZ/DZ 6/1

Additional Notes

  • The BMW Z4 Coupé E86 manual transmission fluid specifications cover two distinct variants across the 2006-2008 model years: the Z4 Coupé 3.0si and the Z4 M Coupé.
  • An initial fill capacity of 1.6 liters applies to all three configurations listed, representing the total fluid volume required when filling a dry or overhauled transmission from empty.
  • A service fill capacity of 1.5 liters applies across all three configurations, reflecting the slightly lower volume needed during a routine fluid change, where residual fluid remains in the transmission after draining.
  • The 0.1-liter difference between the initial fill and service fill capacities is consistent across every listed configuration, indicating a uniform residual volume retained in the transmission after a standard drain procedure.
  • The Z4 Coupé 3.0si appears in two separate rows distinguished by transmission label: one specifying MTF-LT2 fluid and another specifying MTF-LT3 fluid, both sharing identical 1.6-liter initial and 1.5-liter service fill capacities.
  • The Z4 M Coupé for 2006-2008 is listed exclusively with the MTF-LT3 label, carrying the same 1.6-liter initial and 1.5-liter service fill capacities as the 3.0si variants.
  • All three rows carry a normal use condition, meaning the stated capacities and fluid specifications apply under standard operating circumstances rather than severe or track-use duty cycles.

Other Systems