Austin Montego

Automatic transmission fluid capacity & service interval

Austin Montego automatic transmission fluid capacity is 3 liters. Service intervals include checks at 20000 km and changes at 40000 km or 24 months. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Montego 1.3 (1986-1990)
  • Use: Normal
  • Capacity 3 liter
  • Check 20000 km
  • Change 40000 km/ 24 months
  • Code: 3/1
Montego 1.6 (1986-1990)
  • Use: Normal
  • Capacity 3 liter
  • Check 20000 km
  • Change 40000 km/ 24 months
  • Code: 3/1
Montego 2.0 (1986-1990)
  • Use: Normal
  • Capacity 3 liter
  • Check 20000 km
  • Change 40000 km/ 24 months
Montego 2.0i (1986-1990)
  • Use: Normal
  • Capacity 3 liter
  • Check 20000 km
  • Change 40000 km/ 24 months
Montego 1.3 (1984-1986)
  • Use: Normal
  • Capacity 3 liter
  • Check 20000 km
  • Change 40000 km/ 24 months
  • Code: 3/1
Montego 1.6 (1984-1986)
  • Use: Normal
  • Capacity 3 liter
  • Check 20000 km
  • Change 40000 km/ 24 months
  • Code: 3/1

Additional Notes

  • The Austin Montego automatic transmission fluid capacity is 3 liters across all listed engine variants, spanning the 1.3, 1.6, 2.0, and 2.0i configurations from 1984-1990. A 3-liter figure typically represents a service fill rather than a full overhaul capacity, meaning fluid exchanged during a routine drain-and-fill will not account for the total volume held within the torque converter.
  • The 1.3 and 1.6 engine variants are designated as a transmission, automatic, while the 2.0 and 2.0i variants from 1986-1990 are designated as a transaxle, automatic. A transaxle integrates the transmission and differential into a single housing, which is a structural distinction reflected in the component labeling rather than the fluid capacity, which remains 3 liters across both designations.
  • All six configurations share an identical service interval structure under normal use conditions: a fluid check at 20,000 km and a fluid change at 40,000 km or 24 months, whichever comes first. The dual-trigger change interval means time elapsed can mandate a fluid change independently of distance traveled.
  • The check interval of 20,000 km falls at the midpoint between fluid changes, placing a routine inspection at exactly half the distance of the full change cycle. This interval structure allows for condition monitoring without committing to a full fluid replacement at each service visit.
  • The 1.3 variant spans two distinct production sub-periods, 1984-1986 and 1986-1990, yet carries identical fluid capacity and service interval specifications across both. The same pattern applies to the 1.6 variant, where the 1984-1986 and 1986-1990 sub-periods share the same 3-liter capacity and 40,000 km or 24-month change interval.
  • The 2.0 and 2.0i variants both begin in 1986, with no earlier entries listed for those engine sizes. Both share the 3-liter transaxle fluid capacity and the 40,000 km or 24-month change interval under normal use conditions, consistent with the rest of the Montego automatic fluid specifications.

Other Systems