Alfa Romeo Stelvio, 949 (EU)

Transfer case fluid capacity & service interval

Alfa Romeo Stelvio, 949 (EU) transfer case fluid capacity ranges from 0,5 to 0,7 liters. The service interval is 120000 km. The data covers 10 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Stelvio 2.9 V6 QV (382 kW) (2023- )
  • Use: Normal
  • Capacity 0,7 liter
  • Change 120000 km
Stelvio 2.0 T4 MultiAir (184 kW) Q4 (2020-2023)
  • Use: Normal
  • Capacity 0,7 liter
  • Change 120000 km
Stelvio 2.9 V6 QV Racing (382 kW) (2019-2020)
  • Use: Normal
  • Capacity 0,7 liter
  • Change 120000 km
Stelvio 2.2 JTD (140 kW) Q4 AdBlue (2018-2023)
  • Use: Normal
  • Capacity 0,7 liter
  • Change 120000 km
Stelvio 2.0 T4 MultiAir (147 kW) Q4 (2017-2023)
  • Use: Normal
  • Capacity 0,5-0,7 liter
  • Change 120000 km
Stelvio 2.0 T4 MultiAir (206 kW) Q4 (2017- )
  • Use: Normal
  • Capacity 0,7 liter
  • Change 120000 km
Stelvio 2.2 JTD (132 kW) Q4 AdBlue (2017-2018)
  • Use: Normal
  • Capacity 0,7 liter
  • Change 120000 km
Stelvio 2.2 JTD (154 kW) Q4 (2017-2018)
  • Use: Normal
  • Capacity 0,7 liter
Stelvio 2.2 JTD (154 kW) Q4 AdBlue (2017- )
  • Use: Normal
  • Capacity 0,7 liter
  • Change 120000 km
Stelvio 2.9 V6 QV (375 kW) (2017-2023)
  • Use: Normal
  • Capacity 0,7 liter
  • Change 120000 km

Additional Notes

  • The Alfa Romeo Stelvio 949 (EU) transfer case fluid capacity across nearly all configurations is 0.7 liter, which is a typical service fill volume for a compact transfer box of this type. A service fill reflects the amount of fluid needed when draining and refilling during routine maintenance, as opposed to a dry fill used after a full overhaul or replacement.
  • The 2.0 T4 MultiAir (147 kW) Q4 covering 2017-2023 is the only configuration with a capacity range of 0.5-0.7 liter rather than a fixed 0.7 liter value. A range like this generally indicates that the actual fill level depends on the drain angle or residual fluid left in the unit, making the upper figure the target when performing a complete drain.
  • All configurations that include a change interval specify 120,000 km under normal use conditions. Normal use in service interval terminology refers to standard on-road driving without the added stress of frequent towing, off-road operation, or extreme temperature exposure, which would typically trigger a shorter severe-use interval.
  • The 2.2 JTD (154 kW) Q4 covering 2017-2018 lists a capacity of 0.7 liter but carries no change interval in the specifications. The absence of a change interval entry means no fluid replacement schedule is recorded for that configuration, unlike the otherwise consistent 120,000 km interval seen across the petrol and diesel variants.
  • The diesel lineup spans two distinct displacement and power outputs: the 2.2 JTD available in 132 kW, 140 kW, and 154 kW variants. Despite the differences in power output, all three share the same 0.7 liter transfer case capacity, indicating a common transfer box unit across the diesel range.
  • The 2.0 T4 MultiAir petrol engines cover three power outputs: 147 kW, 184 kW, and 206 kW. The 184 kW variant entered the specification from 2020-2023, while the 147 kW and 206 kW variants both have earlier start dates of 2017, reflecting a staggered introduction of power variants within the same engine family.
  • The high-performance 2.9 V6 QV variants, including the 375 kW (2017-2023), 382 kW (2023- ), and the Racing edition at 382 kW (2019-2020), all share the same 0.7 liter transfer case capacity and 120,000 km change interval as the lower-output four-cylinder configurations. The shared specification suggests the transfer box hardware is consistent across the Stelvio Q4 drivetrain regardless of engine output level.

Other Systems