Valpadana 400 series

Coolant capacity & service interval

Valpadana 400 series uses coolant with a capacity of 10 liters. Service intervals occur every 1000 hours or 12 months. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
445, ITL 3102 IL (1994-2010)
  • Use: Normal
  • Capacity 10 liter
  • Change 1000 hours/ 12 months
450, ITL 3105 EL (1994-2010)
  • Use: Normal
  • Capacity 10 liter
  • Change 1000 hours/ 12 months
460, ITL 3100 FLT (1994-2010)
  • Use: Normal
  • Capacity 10 liter
  • Change 1000 hours/ 12 months
460, ITL 4100 FL (1994-2010)
  • Use: Normal
  • Capacity 10 liter
  • Change 1000 hours/ 12 months
475, ITL 4100 FLT/ELT (1994-2010)
  • Use: Normal
  • Capacity 10 liter
  • Change 1000 hours/ 12 months
490, ITL 4105 FLT/ELT (1994-2010)
  • Use: Normal
  • Capacity 10 liter
  • Change 1000 hours/ 12 months

Additional Notes

  • All six configurations in the Valpadana 400 series share a uniform cooling system capacity of 10 liters, indicating a consistent engine bay and radiator architecture across the range despite differences in engine designation.
  • The 10-liter figure represents the total cooling system fill volume, which in agricultural equipment typically accounts for the radiator, engine block passages, hoses, and any auxiliary heating circuits combined.
  • The change interval of 1000 hours or 12 months, whichever comes first, applies under normal use conditions across all listed configurations. The dual-trigger format is standard for machinery that may accumulate operating hours at varying rates depending on seasonal workloads.
  • The 1000-hour threshold is a common benchmark in agricultural tractor servicing, reflecting the extended drain intervals that modern coolant formulations support compared to older glycol-based products with shorter service lives.
  • Engine designations across the 400 series span both three-cylinder units (ITL 3102 IL, ITL 3105 EL, ITL 3100 FLT) and four-cylinder units (ITL 4100 FL, ITL 4100 FLT/ELT, ITL 4105 FLT/ELT), yet the cooling system capacity remains identical at 10 liters across both cylinder counts.
  • The 475 and 490 models carry engine codes with FLT/ELT suffixes, indicating multiple transmission or drive variants within a single model designation, both of which share the same 10-liter capacity and 1000-hour/12-month service interval.
  • The 460 model appears with two distinct engine designations, the ITL 3100 FLT and the ITL 4100 FL, representing a three-cylinder and a four-cylinder option respectively within the same tractor model, each specifying the same 10-liter cooling system capacity.

Other Systems