Ursus 32/34 series

Power steering fluid capacity & service interval

Ursus 32/34 series requires 7 liters of power steering fluid. Service intervals include checking every 100 hours and changing every 800 hours. The data covers 7 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • 1032 2WD / 1034 4WD (1992- )
  • System, power steering
  • Use: Normal
  • Capacity 7 liter
  • Check 100 hours
  • Change 800 hours
  • 1132 2WD / 1134 4WD (1992- )
  • System, power steering
  • Use: Normal
  • Capacity 7 liter
  • Check 100 hours
  • Change 800 hours
  • 1232 2WD / 1234 4WD (1992- )
  • System, power steering
  • Use: Normal
  • Capacity 7 liter
  • Check 100 hours
  • Change 800 hours
  • 1434 4WD (1992- )
  • System, power steering
  • Use: Normal
  • Capacity 7 liter
  • Check 100 hours
  • Change 800 hours
  • 1634 4WD (1992- )
  • System, power steering
  • Use: Normal
  • Capacity 7 liter
  • Check 100 hours
  • Change 800 hours
  • 832 2WD / 834 4WD (1992- )
  • System, power steering
  • Use: Normal
  • Capacity 7 liter
  • Check 100 hours
  • Change 800 hours
  • 932 2WD / 934 4WD (1992- )
  • System, power steering
  • Use: Normal
  • Capacity 7 liter
  • Check 100 hours
  • Change 800 hours

Additional Notes

  • Across all Ursus 32/34 series variants covered by these specifications — including the 832, 932, 1032, 1132, 1232, 1434, and 1634 — the hydraulic system and power steering share a combined fluid capacity of 7 liters. In agricultural tractors, a shared hydraulic and power steering circuit is a common design, meaning a single fluid reservoir serves both functions simultaneously.
  • The 7-liter capacity figure applies uniformly across both 2WD and 4WD configurations within the series. The addition of front-wheel drive hardware in 4WD variants does not alter the stated hydraulic and power steering fluid volume.
  • A fluid level check interval of every 100 hours of operation applies to all listed variants under normal use conditions. In hour-based service schedules typical of agricultural machinery, 100-hour checks are a standard interval for monitoring fluid condition and level without performing a full drain and refill.
  • The fluid change interval is set at 800 hours under normal use conditions across all listed variants. An 800-hour change cycle represents a relatively extended drain interval, consistent with the operating patterns of farm tractors that accumulate hours gradually over seasonal work.
  • The ratio between the check interval and the change interval is 1:8, meaning fluid level is inspected eight times before a full fluid replacement is due. This structure allows for early detection of fluid loss or contamination well in advance of the scheduled change.
  • All seven variants in the specifications carry an identical set of capacity and interval values, indicating no differentiation in hydraulic and power steering service requirements between the lower-displacement models such as the 832 and the higher-displacement models such as the 1634.
  • All listed variants share a starting year of 1992, and the specifications apply uniformly from that point forward for each model in the series.

Other Systems