Renault MX, MS, MA, ME, PX, PS, PA, PE

Differential fluid capacity & service interval

Renault MX, MS, MA, ME, PX, PS, PA, PE models require 3,55 liters of differential fluid. Service intervals include checking at 100 hours and changing at 800 hours. The data covers 7 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • 58-34 ME, MA, MS, MX 4WD (1989-1994)
  • Front
  • Use: Normal
  • Capacity 3,55 liter
  • Check 100 hours
  • Change 800 hours
  • Code: (4x4)
  • 65-34 ME, MA, MS, MX 4WD (1989-1994)
  • Front
  • Use: Normal
  • Capacity 3,55 liter
  • Check 100 hours
  • Change 800 hours
  • Code: (4x4)
  • 70-34 PE, PA, PS, PX 4WD (1989-1994)
  • Front
  • Use: Normal
  • Capacity 3,55 liter
  • Check 100 hours
  • Change 800 hours
  • Code: (4x4)
  • 75-34 ME, MA, MS, MX 4WD (1989-1994)
  • Front
  • Use: Normal
  • Capacity 3,55 liter
  • Check 100 hours
  • Change 800 hours
  • Code: (4x4)
  • 80-34 PE, PA, PS, PX 4WD (1989-1994)
  • Front
  • Use: Normal
  • Capacity 3,55 liter
  • Check 100 hours
  • Change 800 hours
  • Code: (4x4)
  • 85-34 ME, MA, MS, MX 4WD (1989-1994)
  • Front
  • Use: Normal
  • Capacity 3,55 liter
  • Check 100 hours
  • Change 800 hours
  • Code: (4x4)
  • 90-34 ME, MA, MS, MX 4WD (1989-1994)
  • Front
  • Use: Normal
  • Capacity 3,55 liter
  • Check 100 hours
  • Change 800 hours
  • Code: (4x4)

Additional Notes

  • All seven configurations listed — spanning the Renault MX, MS, MA, ME, PX, PS, PA, and PE series in 4WD form from 1989-1994 — share an identical front differential fluid capacity of 3.55 liters. This uniformity across both the M-series and P-series platforms suggests a common front axle assembly was used regardless of model designation or power rating within the 34-frame 4WD lineup.
  • A capacity of 3.55 liters is a service fill figure, representing the amount of fluid required when refilling a drained but otherwise intact differential housing. Overhaul capacities, which account for fluid retained in bearings and passages during a full disassembly, would typically differ.
  • The check interval for front differential fluid across all listed configurations is every 100 hours of operation. In agricultural equipment, hour-based intervals reflect actual working time rather than calendar time, making them more relevant to machines that may sit idle for extended periods between seasons.
  • The change interval is set at 800 hours under normal use conditions for all seven configurations. At this interval, a machine operating roughly 500 hours per year would reach a fluid change approximately every 19 months, while one used more intensively at 1,000 hours per year would reach the interval in under a year.
  • The normal use condition designation applies uniformly across all rows. In service interval terminology, normal use typically refers to standard operating environments without the added stress of extreme loads, high contamination exposure, or frequent water crossings — conditions that would otherwise warrant shortened intervals.
  • The M-series configurations (ME, MA, MS, MX) cover model numbers 58-34, 65-34, 75-34, 85-34, and 90-34, while the P-series configurations (PE, PA, PS, PX) cover the 70-34 and 80-34. Despite the different series designations, both groups share the same 3.55-liter front differential capacity and identical service intervals.

Other Systems