Fendt C series

Manual transmission fluid capacity & service interval

Fendt C series manual transmission fluid capacity is 12 liters. Service intervals include checks at 225 hours and fluid changes at 450 or 500 hours. The data covers 9 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
5275 C SL, Stage V (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Change 500 hours
5275 C (2016- )
  • Use: Normal
  • Capacity 12 liter
  • Change 500 hours
5275 C PL-PLI (2016- )
  • Use: Normal
  • Capacity 12 liter
  • Change 500 hours
6335 C (2016- )
  • Use: Normal
  • Capacity 12 liter
  • Change 500 hours
6335 C PL (2016- )
  • Use: Normal
  • Capacity 12 liter
  • Change 500 hours
5270 C (2008-2011)
  • Use: Normal
  • Capacity 12 liter
  • Check 225 hours
  • Change 450 hours
5270 C-AL (2008-2011)
  • Use: Normal
  • Capacity 12 liter
  • Check 225 hours
  • Change 450 hours
6300 C (2008-2011)
  • Use: Normal
  • Capacity 12 liter
  • Check 225 hours
  • Change 450 hours
6300 C-AL (2008-2011)
  • Use: Normal
  • Capacity 12 liter
  • Check 225 hours
  • Change 450 hours

Additional Notes

  • All Fendt C series configurations listed carry a transaxle manual transmission fluid capacity of 12 liters, a figure consistent with the integrated transaxle design where the gearbox and axle share a common fluid reservoir rather than separate sumps.
  • The 2008-2011 configurations, including the 5270 C, 5270 C-AL, 6300 C, and 6300 C-AL, specify both a fluid check interval at 225 hours and a full fluid change at 450 hours under normal use conditions, establishing a two-stage service schedule within a single change cycle.
  • The 225-hour check interval on the 2008-2011 models serves as a midpoint inspection within the 450-hour change cycle, allowing verification of fluid level and condition without a full drain and refill at that point.
  • Configurations introduced from 2016 onward, such as the 5275 C, 5275 C PL-PLI, 6335 C, and 6335 C PL, list only a change interval at 500 hours with no intermediate check interval specified, representing a longer service cycle compared to the 450-hour change interval of the 2008-2011 models.
  • The 5275 C SL Stage V, introduced from 2020, shares the same 12-liter capacity and 500-hour change interval as the other 2016-onward variants despite carrying a Stage V emissions designation, indicating the transmission service schedule is not affected by the engine emissions tier on these machines.
  • The AL suffix on the 5270 C-AL and 6300 C-AL denotes an alternative configuration variant, yet both carry identical capacity and service interval specifications to their non-AL counterparts, meaning the variant designation does not alter the transaxle fluid requirements.
  • All intervals across every configuration are expressed in operating hours rather than calendar time, which is standard practice for agricultural machinery where annual usage varies widely between operators and seasonal workloads.

Other Systems