Claas Avero

Brake fluid capacity & service interval

Claas Avero brake fluid capacity is 0,5 liter. Service intervals include a check every 10 hours and a change every 24 months. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Avero 160 Stage IIIA, 560 (56000011-) (2019- )
  • Use: Normal
  • Capacity 0,5 liter
  • Check 10 hours
  • Change 24 months
Avero 160 Stage IV, 560 (56000011-) (2019- )
  • Use: Normal
  • Capacity 0,5 liter
  • Check 10 hours
  • Change 24 months
Avero 160 Stage V, 560 (56000011-) (2019- )
  • Use: Normal
  • Capacity 0,5 liter
  • Check 10 hours
  • Change 24 months
Avero 240 Stage IIIA, 560 (56000011-) (2019- )
  • Use: Normal
  • Capacity 0,5 liter
  • Check 10 hours
  • Change 24 months
Avero 240 Stage IV, 560 (56000011-) (2019- )
  • Use: Normal
  • Capacity 0,5 liter
  • Check 10 hours
  • Change 24 months
Avero 240 Stage V, 560 (56000011-) (2019- )
  • Use: Normal
  • Capacity 0,5 liter
  • Check 10 hours
  • Change 24 months

Additional Notes

  • The Claas Avero hydraulic brake system holds 0.5 liter across all listed configurations, which is a relatively small reservoir volume consistent with a dedicated brake fluid circuit rather than a shared hydraulic system.
  • A check interval of 10 hours applies to all six configurations under normal use conditions, reflecting the frequent inspection demands typical of agricultural machinery operating in demanding field environments.
  • The change interval is set at 24 months for every listed configuration, meaning fluid renewal is time-based rather than hour-based, which is common for brake fluid due to moisture absorption over time degrading its boiling point.
  • Both the Avero 160 and Avero 240 variants share identical brake fluid capacity and service intervals across their respective Stage IIIA, Stage IV, and Stage V engine emission tiers, indicating no variation in brake system specifications between engine configurations starting from serial number 56000011.
  • The Stage IIIA, Stage IV, and Stage V designations refer to European non-road mobile machinery emission standards, and the fact that all three tiers carry the same 0.5 liter capacity and service schedule suggests the brake circuit design was not altered between emission-tier updates.
  • The 10-hour check interval is notably short in calendar terms for machines that may log significant hours during harvest season, meaning fluid level inspections could occur multiple times within a single week of intensive operation.

Other Systems