Case - IH Farmall A

Differential fluid capacity & service interval

Case - IH Farmall A differential fluid capacity ranges from 6 to 7 liters. Service intervals include checking at 300 hours and changing at 1200 hours or 24 months. The data covers 7 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Farmall 55A (2019- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Farmall 65A (2019- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Farmall 75A (2019- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Farmall 105A (2014- )
  • Front
  • Use: Normal
  • Capacity 7 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Farmall 115A (2014- )
  • Front
  • Use: Normal
  • Capacity 7 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Farmall 85A (2014- )
  • Front
  • Use: Normal
  • Capacity 7 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months
  • Farmall 95A (2014- )
  • Front
  • Use: Normal
  • Capacity 7 liter
  • Check 300 hours
  • Change 1200 hours/ 24 months

Additional Notes

  • The front differential fluid capacity across Case-IH Farmall A series models falls into two distinct groups: 6 liters and 7 liters. The Farmall 55A, 65A, and 75A share the 6-liter capacity, while the Farmall 85A, 95A, 105A, and 115A all require 7 liters.
  • The 7-liter front differential capacity on the Farmall 85A, 95A, 105A, and 115A reflects the larger front axle housings typical of higher-horsepower tractors, which require greater fluid volume to maintain adequate lubrication across wider gear sets and bearing surfaces.
  • The 6-liter front differential capacity on the Farmall 55A, 65A, and 75A corresponds to a smaller front axle assembly suited to the lower power output of those models, where a reduced fluid volume is sufficient for proper lubrication.
  • All seven models share an identical front differential fluid check interval of 300 hours under normal use conditions. A check interval shorter than the change interval allows for early detection of fluid contamination or level loss without committing to a full drain and refill.
  • The front differential fluid change interval is specified at 1200 hours or 24 months, whichever comes first, under normal use conditions across all listed models. The dual-trigger format means time elapsed can mandate a change even when the hour threshold has not been reached, which is relevant for low-utilization equipment.
  • The Farmall 55A, 65A, and 75A carry a starting year of 2019, while the Farmall 85A, 95A, 105A, and 115A carry a starting year of 2014. Both the 6-liter and 7-liter capacity groups therefore represent separate model introduction periods within the Farmall A lineup.
  • All specifications listed apply to normal use conditions. The 1200-hour or 24-month change interval is tied specifically to that use classification, meaning operation outside normal conditions would fall under a different service schedule not reflected in these rows.

Other Systems